Winkelwagentje

Winkelwagen is nog leeg.

Winkelwagen is nog leeg.
Op voorraad

1 x SabreCut SCRIW35_1 35mm x 152mm Impact Rated Flat Wood Spade Bit voor naaldhout hardhout spaanplaat

5,99€ 11,49€
Gratis verzending bij bestellingen boven 25,99€

Productdetails

  • 1 stuk 35mm x 152mm Impact Rated Spade Bit
  • Extra dikke schacht voor stevigheid en duurzaamheid
  • Geruite randen voor snel boren en schone gaten - Zachthout, Hardhout, Spaanplaat, Multiplex etc
  • Precisie grondsnijpunten geoptimaliseerd voor snellere penetratie en verhoogde boorsnelheid in een verscheidenheid aan natuurlijke en door de mens gemaakte materialen
  • Geleverd in een maat gemarkeerde PVC-hoes voor bescherming en eenvoudige identificatie


Productbeschrijving

Inhoud van de verpakking:
- 1 stuk 35mm x 152mm impact rated spade bit
SabreCut Revolution Impact Hout Spade Bits
SabreCut Revolution Impact rated spade bits heeft een extra dikke geharde schacht ontworpen voor gebruik in slagschroevendraaiers, combi boren en boormachines. Professionele kwaliteit impact spade bits met een universele 1/4" hex. Kan ook worden gebruikt in standaard klauwplaten voor een veilige antislip pasvorm.
Compatibel met:
Elke machine die een 1/4" Hex.


Customer
24 juni 2025
Just the job
Client d'
29 april 2025
Rien à dire très bonne mèche à bois
Gabriele
14 april 2025
Pacco arrivato in anticipo...Arricolo di ottima qualità fa il suo dovere alla perfezione.
JACB
20 maart 2025
Using it to cut holes in a laminate floor to accommodate the radiator pipes, gave a clean cut but quite slow.
Lankylad
18 oktober 2024
I am a regular DIY'er over many years, and I have used many spade bits of varying prices and quality. I can in all honesty say that this flat spade bit is the very best I have ever used. I have just fitted a new lock and needed this 35mm bit. The bit went through the wooden door without any effort, it was brilliant!If anyone is intending doing a similar job and has never done the job before, my tip is to drill a pilot hole through the wood first then use the spade bit to go partly through on one side, then finish the hole by going in from the other side. This way you will get a clean hole without any splintering.