1,08 Breedte Universele DIN-rail Mount Clip Snap in Din-Rail Montagebeugels DIN Rail Vaste Klem Aluminiumlegering Solid State Relais Clip voor 35mm Din Rail Zwart 4-pack voor verzonken kop M3

I got these clips, along with this same seller's 1.08 width DIN rails for tidying up my shop's 3D printer farm controllers and various networking gear, and they were delivered on-time and in perfect condition. While I was waiting for them to arrive, I had printed various mounting plates for everything to match up to the clips and was ready to go. Unfortunately, however, these clips did not work like the photos and videos depicted on the product page:All but one photo depicted installing them with the spring of the retaining clip *behind* the top "lip" of the rail. This installation method was outright impossible because when I tried to secure the bottom of the clip to the rail's lower edge, it required so much force to engage that the rail's bottom edge just failed and flattened out (once that was done, the rail was junk thanks to the deformation). As a result, the ONLY way I could get the clips to work were as depicted in the photo that says "Install on the Switch/Injector/Media Converter" on it. In this manner, the spring is just simply wedged between the rail and clip, which offers very little holding power. Obviously, this also limits the weight of items mountable using these clips - which may not sound like a big deal, but when you've also got the weight of cables pulling on whatever is mounted, it can tend to cause the clips to release unexpectedly.In conclusion, these are a good choice if you're looking to mount lightweight items to rails cheaply - but if you're looking for something that's fool-proof and plug-and-play, spend a few dollars more and look elsewhere.

The product looks great but it performs okay. The retainer springs tent to fall out of the dim clip after a few uses. It will work great for a temp or quick job. Not a commercial application.