Winkelwagentje

Winkelwagen is nog leeg.

Winkelwagen is nog leeg.
Op voorraad

2 Pin Waterdichte Connector SP17 IP68 Kabel Plug Socket In-line Type

5,99€ 11,69€
Gratis verzending bij bestellingen boven 25,99€
  • SP17 Series Connector, Recht, In-Line Type, In-Line Socket en Plug, Soldeer Contact, 2 Pin
  • Met IP68 waterdichte classificatie
  • Shell diameter (de uitsparing diameter van het paneelgat): 17mm
  • Koppeling met schroefdraad, eenvoudig snel verbinden en loskoppelen koppeling
  • Kabel buitendiameter bereik van 6-10mm, hogere spanning, het is een zeer sterke en zeer taaie connector ontworpen voor veel zwaardere omgevingen.


Hoofd Specificatie
Oriëntatie: Recht
Beëindiging Stijl: Soldeer Cup
Opzettend Type: Paneel zet / kabel
Aantal posities: 2 Pin
Geslacht: Man en Vrouw (één paar)
Schakelaartype: één paar (Plug en Socket)
Opzettend Functie: schot/soldeertype


Hr. Chm de wit
12 juni 2025
Prima connector welke in mijn geval gebruikt is om een brandstof [nivo-sensor]aan te sluiten.
Jack Sparrow
30 april 2025
Ho diversi accessori elettrici in barca, ed essendo un center consolle i collegamenti esterni sono sempre un problema. Questi connettori svolgono egregiamente il loro lavoro: perfettamente stagni, robusti e con una connessione robusta facendo la stagnatura direttamente sui poli interni. Prodotto semplice, ma perfettamente funzionale. Si trovano in tante varianti da 2 a 9 poli.Prodotto consigliato.Spero di esserti stato utile.
Kunde
24 februari 2025
Lieferung war in Ordnung. Bauteile sind robust und gut verarbeitet.
C J Bennett.
14 februari 2025
Really well made, robust connector. Recommended.
Carine
10 februari 2025
Ce produit était destiné à une guirlande électrique de Noël. L’embout ne rentre pas dans le transformateur.
heartsturgeon
24 november 2024
My plan is to use this to connect a solar panel to my indoor battery power station. The waterproofing glands seem very good and there is an O ring where the two halves of the connector screw together. When separated the fixed end has a sturdy screw on cap to keep it dry. Attachment of the electrical cable needs to be done with a solder joint, I will also use shrink tube for protection of each terminal, the terminal pins are made from a good quality copper and aren't just folded sheet but are solid in construction.