Winkelwagen is nog leeg.
Winkelwagen is nog leeg.Productbeschrijving
【MacBook Pro 16 Palm Rest Protector Set 2021 - Bescherm je MacBook perfect】
👉Speciaal ontwerp voor MacBook Pro 16 inch model A2485, past niet op andere modellen!
👉Onze MacBook Pro 16 palmsteunbeschermer kan je MacBook niet alleen beschermen tegen krassen, maar ook netjes
zonder resten achter te laten bij het verwijderen.
Waarom kiezen voor onze MacBook Pro 16 Palm Rest Trackpad Protector?
✔ Onzichtbare bescherming
✔ Ultradun en luchtbelvrij
✔ Krasbestendig en van hoge kwaliteit
✔ Gevoelig voor aanraking
✔ Volledige bescherming voor je MacBook
Kenmerken:
👉Het is gemaakt van duurzaam milieuvriendelijk materiaal en perfect voor dagelijks gebruik.
👉Het is gemakkelijk aan te brengen, zonder luchtbellen en schoon zonder resten achter te laten wanneer het wordt verwijderd.
👉De polssteunbeschermer heeft geen invloed op het uiterlijk van je MacBook en je aanraakprestaties.
Inhoud van de verpakking:
1 x MacBook Pro 16 palmsteunbeschermer
1 x beschermhoesje voor MacBook Pro 16
MacBook Pro 16 Toetsenbordhoes TPU X1
✉Als je vragen hebt, neem dan gerust contact met ons op.
drakedog
25 juni 2025
Nice quality products, kind customer service!
Ignacio C. Villegas
15 mei 2025
it keeps my Mac clean and safe
Jacob Kitchen
5 april 2025
I bought this thinking it would perfectly fit my MacBook Pro. I have the A2548 model which is listed in the description. However, when I put the pads on, the palm rest one was too big and the mouse pad was too small. Very disappointed in this product.
Humbeline
11 maart 2025
I like how the color blends and matched with the regular color of the Mac. But… it keeps bubbling up- like it’s not sticky enough to stay down. I always have to keep putting the sticker down- the adhesive is not strong enough to stay down. If that makes sense
CC
24 februari 2025
Paid almost $10 and for the quality would say it probably cost about $2 to make. Had a terrible time getting the backing off, took a pair of tweezers to get a starting point. Not a perfect fit to my 2022 Mac Book Pro, just a bit hanging over the edge of my keyboard (nothing to interfere but enough to bug me). All in all, if I paid even half of what I did I would say worth it, but not worth $10
TV Lighter
25 januari 2025
The final result seem to provide a good level of scratch protection from my watch. BUT the install too greater effort than expected. First issue: Obtaining a start point to remove the backing. My solution was to use the fine razor edge to slip between the two layers and provide a raised edge to remove the backing. Second, ad MOST DISAPPOINTING was the fit! The material was too wide and deep. There was a 2mm edge extending beyond the Body. A careful use of a new sharp hobby knife allow me to trim off the excess. In my opinion I should not have to clean up the fit. On a positive note, A very clean final appearance.
Aanbevolen producten
Misschien vind je dit ook leuk