All I wanted was to integrate this with Hubitat and it has been working as expected. I mostly just use remote control and scheduled open and close.I fond it helpful that the z-wave pairing button allows you to close and open during testing.Pairing was simple.

Habe Rolloschalter als Ersatz für einige defekte Rollosteuermodule gesucht und bin hier fündig geworden. Ich verwende diese Module zusammen mit der Steuersoftware von Home Assistant (sehr zu empfehlen!), diese werden über das Z-Wave Protokoll eingebunden. Die Module lassen sich sehr einfach kalibrieren (wegen den unterschiedlich langen Verfahrzeiten bei den Jalousien bei Up und Down Bewegung) und arbeiten nach erfolgter Kalibrierung sehr präzise. Die Teile sind ein wenig teurer als vergleichbare ZigBee_-Module, jedoch ist Z-Wave nach meiner Erfahrung das wesentlich betriebssicherere Protokoll und vor allen Dingen gibt es hier keine Inkompatibilitäten. Klare Kaufempfehlung von meiner Seite!

I bought this product to attempt to control a standard shutter in my office building. it was installed by a certified electrician and then i attempted to install it as per the manufacturers literature.firstly it would seem that they have multiple instruction booklets for this device once i found the correct one and followed all the instructions it was not possible top get the device to function for said application. in addition many of the commands stated in the instruction manual did not work on the device itself. at some point the instruction manual says you can configure the device from with in you smart things app... no there are no options for configuration that work and also no way to set the parameters of functionality.after contacting aeotec consumer service i was sent an email with some generic instructions of how to work around the inadequate software solution. i had to install code on to my hub that re configures the software on the shutter controller make some generic changes that they suggested in the email and then reset the shuter controller to its previous operating software... as you can see this is not plug and play at all. after doing all of that it still did not work and there is no in-depth explanation of how to train the controller to know when the shutter is up or down or configure any of its parameters.i have a feeling they have modified their light dimmer to work for shutters but have not bothered to write the software necessary to operate the device for it purpose.i am a fairly technically oriented person and yet could not use this and it would seem the only way to actually get it to function would be by writing code specifically for use. which is far beyond a plug and play solution. very disappointed by the product and the 7 hours i spent trying to get it to work.

Le dimensioni del dispositivo sono davvero contenute e consentono la sua installazione anche dentro una scatola 503, a patto che non ci sia affollamento di frutti e cavi. Se da una parte la installazione del dispositivo fisico è abbastanza semplice, il setup operativo non e dei più semplici: si va per tentativo e bisogna trovare la combinazione giusti per far salire e scendere la tapparella in base alla pressione del tasto fisico che comunque ho deciso di lasciare. Inversione dei colori dei cavi elettrici sul dispositivo e sul tasto, inversione del senso di rotazione....insomma una installazione complessa. Per adesso una stella, vedremo nel tempo come si comporta.

Lo he configurado con Domoticz, pero la pega que me ha hecho devolverlo, es que a parte de que son pocos los parámetros de configuración del dispostivo, el tiempo de respuesta tras accionar los interruptores es demasiado largo.Nada que ver con fibaro.