Ainiv Mini spiraalborenset, 10 stuks Mini Twist Drill spiraalboor precisie 0,6 mm - 2,2 mm, 2,35 mm diameter schacht titanium gecoat Tiny Drill bit, voor knutselprojecten en doe-het-zelfprojecten

Lieg auf dem Basteltisch, braucht wenig Platz und kein Kabel stört.Für kleine Bohrungen sehr schön, leise und flott.

I didn’t expect much from this little drill, but it’s actually really handy. It’s lightweight but still feels sturdy, and the three speed settings give just the right amount of control. The USB charging is super convenient—no messing with batteries. It’s perfect for small projects like jewelry or resin crafts, though it’s definitely not for heavy-duty work. The drill bits are tiny, so they can be a little delicate, but as long as you're careful, it does the job really well.

Outil compacte, maniable.Je l’utilise pour percer des trous lors de la réalisation de maquettes en plastique.Adapté pour cette utilisation.

Whilst I acknowledge that this drill is sold as low power, the actuality of it is that it has such little torque that it struggles to drill into even the softest of materials, in my case, PLA (3D printing filament.) Using the smallest of the included bits, it was just about possible to drill a hole through the 1.5mm surface of the printed object. The hope was that the hole could be widened using each successive diameter of bit, but unfortunately this was not the case. As the bits became wider, they simply seized in the preceding pilot hole, with no success at all. At full speed and without load, the drill could be stopped with the lightest of finger pressure. I doubt you could do very much with this drill at all, and would advise against purchasing it. The bits themselves are ok, and in another drill with a bit of torque, might perform well, but with this tool, forget it. I sent mine back for a full refund.

Zunächst dachte ich noch, es läge an einem Bedienungsfehler, oder dass das Teil nicht genügend aufgeladen wäre, als der ‚Bohrkopf‘ beim Kontakt mit der Plastikhülse sofort zum Stehen kam, anstatt sich mit Gusto in das eigentlich recht weich erscheinende Material zu fräsen.Aber nein, nach dem Studium anderer Erfahrungsberichte mit diesem Teil, bin ich überzeugt: dieser ‚Bohrer‘ bohrt nicht…