ANGEEK XR2206 1Hz -1MHz Function Signal Generator Sine/Triangle/Square Output Signal Generator Adjustable Frequency Amplitude（Welding completed）

Description:

Impedance: 600 Ohm + 10%

Frequency: 1Hz - 1MHz

SINE WAVE

Amplitude: 0 - 3V at 9V DC input

Distortion: Less than 1% (at 1kHz)

Flatness: +0.05dB 1Hz - 100kHz

SQUARE WAVE

Amplitude: 8V (no load) at 9V DC input

Rise Time: Less than 50ns (at 1kHz)

Fall Time: Less than 30ns (at 1kHz)

Symmetry: Less than 5% (at 1kHz)

TRIANGLE WAVE

Amplitude: 0 - 3V at 9V DC input

Linearity: Less than 1% (up to 100kHz) 10mA

Debugging steps:

1After completion of welding on IC, XR2206, pay attention to the direction of IC, insert the might damage the chip!

2. check the IC whether against, such as anti please timely correction.

3. Insert the power supply, power supply for 5.5 * 2.1 port, inside outside is negative polarity. For 9-12 v power supply voltage. The waveform may not be stable for more than 12 v

Using the step

1. J1 jumper cap plug in, SIN/TRI blue terminals output sine wave (note J1, J2 can only insert one of)

2. J2 jumper cap plug in, SIN/TRI blue terminals output triangular wave (note J1, J2 can only insert one of)

3. SQU blue terminals output pulse

4. AMP : Sine wave, triangle wave amplitude adjustment

5. FINE : Frequency fine adjustment

6. Coarse : Frequency of coarse adjustment

Note:

Our products have two-years warranty

If you have any questions, please contact us by email first, we will help you solve the problem immediately

Package Included:

1x XR2206 Function Signal Generator （Welding completed）