Argon Forty Argon ONE hoesje voor Raspberry Pi 4

Niks op aan te merken.Snel in huis, werkt zoals gezegd en heb veel plezier ervan.

It is a great case and easy to install with a newb friendly installation guide, The thermalpads are easy to apply and the power button is a nice addition as well.

Daughter bord doesn't provide 4k video and audio over HDMI. When using the original RPi connections there is 100% no problem, Argon messed this (unit) up which cost time to trouble shoot and so on.

I was suprised by the quality of the parts.The top of the case is aluminum which serves as a heatsink and comes with silicone thermal pads.There are two daughter boards that serve to reroute the GPIO and hdmi/audio which seem of very good quality. ( nice components, nice welds without burns or traces of flux )Also included are four stick-on rubber feet.I had a very small fitment issue where the boards are off by a tiny bit but this doesn't interfere with the port openings it just meant i had to squeze a bit until i had put the screws in. I belive this is the cause for the second very small problem, that the case doesn't sit flush and has a slight wobble.These small issues aren't enough for me to remove a star from this product.9.9/10 Would definitely reccomend.

Yes, definitely. For the price, this case is a steal. Solid design and easy assembly, looks great to. I highly recommend removing your SD card before assembly, I didn't have an issue but I did notice if your not careful you could damage your sd card.

I had in my mind that this case would be somewhat bigger than it actually is. Perfect well made little case and everything fitted together nicely. Just beware of the pins used by the case for the power button and fan control as the power button uses the same GPIO as the default 1-Wire GPIO pin and the fan uses the I2C bus. The 1-Wire pin can be changed in the Pi’s boot configuration and the I2C bus supports multiple devices so it wasn’t a deal breaker. The Pi runs much cooler now due to the heatsink being integrated into the case which makes for a larger cooling area and I find it is running some 8-10 degrees cooler even without the fan running. Beats any of those stick on heat sinks hands down. My setup is running Docker with Portainer that is running multiple containers of Node-Red and Grafana. It’s yet to break a sweat and have the fan kick in which starts at a default setting of 50C.

Çok memnunun. Öneririm.

Ho un piccolo server acceso 24/7 su un raspberry pi 4, da quando l'ho installato in questo case ho risolto tutti i miei problemi di temperatura! Il case in se dissipa tutto il calore passivamente e la ventolina aiuta nei momenti di maggior carico!