Winkelwagentje

Winkelwagen is nog leeg.

Winkelwagen is nog leeg.
Op voorraad

AURSINC MMDVM Duplex Hotspot Module Dual Hat V1.5.2 Ondersteuning P25 DMR YSF NXDN DMR Slot 1 + Slot 2 voor Raspberry Pi, Pi Zero (zonder OLED)

22,99€ 42,99€
Gratis verzending bij bestellingen boven 25,99€

1.Stijlnaam:Mmdvm


Productdetails

  • [Uitgebreide compatibiliteit] Ondersteunt DMR, P-25, D-Star en System Fusion. HOGE PRESTATIES: 32-bits ARM-processor, tot 10mW RF-vermogen, volledig getest elk stuk. Compatibel met de Raspberry Pi, inclusief de Pi 1, 2/2b, 3/3b/3b+, 4/4b, Pi Zero, Pi Zero 2W
  • [EENVOUDIGE BEDIENING] De firmware is vooraf geladen en kan eenvoudig worden geüpgraded via software. Ingebouwde LED's met status (Tx, Rx, PTT, modus). Pi-star control Modus selectie: DUPLEX-modus/SIMPLE-modus
  • [FREQUENTIE] UHF 433-900 MHz, VHF 144-220 MHz. OPMERKING: TX=0, RX=0. Modem selecteren: STM32_HS_GPIO. Om het scherm altijd aan te laten staan In de Pi-Star-configuratie moet u ervoor zorgen dat u "OLED Type 3" hebt in het veld voor weergavetype bovenaan de pagina, stelt u Port in: modem
  • [INSTELLING] Wijzig het type modem (elk model dat eindigt op GPIO kan worden ondersteund). Radio/Modem Type: STM32-DVM/MMDVM_HS-Raspberry pi Hoed (GPIO). Ga in het gedeelte Expert naar de MMDVM-host en scrol omlaag naar het gedeelte OLED. Zorg ervoor dat LogoScreensaver is ingesteld op "1", dit laat het scherm altijd aan. Anders wordt het leeg als het inactief is
  • [FIRMWARE UPGRADE] (pi-star / expert / ssh access / user: pi-star pass: raspberry) U kunt upgrade-opdrachten direct uitvoeren zonder jumpers in te stellen (uitgevoerd in de Pi star terminal): sudo pistar-mmdvmhshatflash hs_dual_hat (als dit commando niet werkt, probeer dan deze opdracht: mmdvm.club/index.php/wpsd .html)


Productbeschrijving

BESCHRIJVING

Origineel cysteel: Origineel ECS-TXO-3225-147.4-TR uit de VS.
Duplex variant van MMDVM_HS_Hat
Deze PCB maakt gebruik van de MMDVM_HS .
Het heeft twee ADF7021 aan boord en maakt duplexbediening mogelijk met twee tijdvakken op DMR.

Tips instellen:
Modem selecteren: STM32_HS_GPIO

Inhoud van de verpakking:
1x MMDVM duplex HotSPOT Module
2x Antenne
2x SMA-aansluiting


Ürün modeli eşleşmiyor bozuk
11 augustus 2025
Bozuk ürün
José Mª Gómez de Salazar
10 augustus 2025
No funciona el firmware. No se puede instalar. El oled no enciende
Nik Smeltzer
19 april 2025
I'm new to digital modes. I've been a radio ham for years, but have had a 17 year break and just coming back. Digital modes are all new to me. I already had a Raspberry Pi 2b lying around unused, so I bought this radio module for it. It arrived promptly, I installed Pi-Star and was up and running talking to 2 British stations and an Australian on CQ-UK via my Yaesu FT-70d hand held from my office. The Aussie was using his local repeater in Adelaide and was right by the beach.It couldn't have been easier to set up and it has opened up a whole new world of ham radio that I haven't previously experienced.There are 2 versions, one with and one without the screen. The screen is tiny and not that much use, however, for the very small extra amount, I would get the screen as it gives you status info like callsign, mode (ie Fusion, DMR, DSTAR etc) but more importantly, the IP address, so if you connect it to your phone hotspot, you might have to know the current IP. It also flashes in to life when someone connects to the group you have configured, even if your radio is off. So you can easily see if there is activity without leaving your radio on 24/7.Hope that helps!73, G7IZR
Wolf
6 maart 2025
Ha funzionato giusto un paio di settimane ora devo capire come far valere la garanzia, visto che il tempo del reso è scaduto*** ne ho acquistata un'altra, ha funzionato qualche ora, di nuovo ferma ***
Customer
18 januari 2025
Item was as expected