BIQU CryoGrip Pro Glacier bouwplaat voor K1 Max 3D-printer, dubbelzijdig fijn gestructureerd veerstalen blad, stevige hechting, 310 x 315 mm, 1 stuk

il prodotto funziona come da descrizione, sono soddisfatto

Bought a Bambu A1 and was having tons of adhesion issues right from new. Tried washing with dish soap, wiping with isopropyl, but no go. Wasn't willing to resort to glue. Picked this up, and it holds PLA well at 35 C bed temp. no parts have lifted yet, and there hasn't even been any edge warping. All I did was wash it with dish soap when new. I haven't had to treat it between prints yet (I just avoid touching the print area with my hands). Flexing the sheet from the edges separates the part easily as soon as printing is completed.The sheet seemed to have a slight warp to it right out of the box. Kind of wants to "pop" to one side or the other. This doesn't seem to affect printing on the A1 though (not sure if the magnets are holding it flat or if auto bed leveling is compensating correctly). There is also a slight unfinished portion in the very top, almost as if this is where they hung the sheet while it was sprayed/treated with the surface finish. This seems like a minor issue, especially since you do not print in that area, but the A1 pre-print start up routine DOES go to that area and it has formed a slight blemish in the nearby finish where the print head sits. Again - does not impact the print in any way, but it would be great if the entire sheet had the same finish.tl;dr: Print PLA at 35C bed temp, holds better than stock Bambu textured PEI sheet, consumes less electricity due to lower bed temp.

Très belle plaque. Offerte pour un cadeau qui a beaucoup plu et qui sert très largement pour certains modèles 3D. Je recommande sans hésiter

Funciona genial, sin problemas hasta el momento, solo un apunte, los bosses son un poco cortantes, nada que un lijado fino no arregle

Started life off great with excellent adhesion, but now no longer sticks large prints in the corners. Cleaned with mild organic soap as you do with these plates but the adhesion is simply no longer there.I am on the second side but my stock plates are still running strong after hundreds of prints with this is not even over 50 on the first side.