Winkelwagentje

Winkelwagen is nog leeg.

Winkelwagen is nog leeg.
Op voorraad

Bluelover 10 stuks 5 x 10 cm enkelzijdig koperen prototype papieren PCB-breadboard 2-3-5 gewrichtsgat

4,99€ 9,99€
Gratis verzending bij bestellingen boven 25,99€

Productdetails

  • Breedte: 50 mm


Productbeschrijving

Kenmerken: Standaard striboard is ideaal voor prototyping en constructie circuits, maar het kan lang duren om te gebruiken met componenten met bepaalde pinconfiguraties zoals ICS zoveel tijd moet worden besteed van break-tracks om ervoor te zorgen dat er geen Short bestaat op de tegenovergestelde component pinnen. Deze bpard krijgt rond dit probleem door het hebben van geïsoleerde groepen pinnen. Breadboards solderen PCB, enkelzijdige PCB's, komt overeen met breadboards met power rails. Deze tips zijn vooral handig voor het behoud van een prototype of experiment dat u zojuist op een gelaste broodplank hebt gemaakt door alle onderdelen op hun plaats te lassen. Specificaties: Materiaal: bakeliet Lengte: 100 mm Breedte: 50 mm Dikte: 1,2 mm Gatdiameter: 1 mm Pakket inbegrepen: 10 x PCB enkelzijdig koperen prototype papier


Scrat77
22 juli 2025
Par rapport á une breadboard avec soudure d'autres fournisseurs :- une bande serpente (cela me permet d'avoir un peu partout le GBD- pas de "longues bandes" VCC et GND, mais à la place de nombreuses bandes 2 trous qui démultiplient le nombre de composants que l'on peut mettre- les bandes de différentes tailles sont pratiques- la taille générale permet d'avoir une bonne surface de prototypage pour de petits projetsCela pourrait être plus petit mais cela serait moins "universel"- enfin le matériel est de bonne qualité !Les soudures accrochent bien
SteccoSte
14 juli 2025
Un paio delle schede che mi sono arrivate sono difettose e difficilmente utilizzabili. Le altre sembrano OK. DA CONTROLLARE prima di usare!
Xavier R.
3 april 2025
Monté un arduino. Para aprovechar la pista que serpentea, recomiendo cortarla por el lado opuesto a la hilera de dos pines. De se modo se tiene + y - y solo queda puentear.
Gavin
19 maart 2025
Bought this because it was advertised as 10x5cm, which was the exact size I needed for a project and quite a tricky size to find. However the actual size was 9.5cm x 5cm which meant I couldn't mount the project in the way I planned. On the positive side, the connected copper traces were useful and the board is good and sturdy.
Nick
4 januari 2025
I use this to integrate Arduino with other components and electronics sub-boards connected to the Arduino. It's good in that the basic layout is ideal for mounting small Arduinos such as the Nano and the many different circuit boards and components that you might want to connect to a Nano. BUT (and this is a real annoyance) it has only one common rail which you can use for ground; but it would be so much more useful if it had 2 common rails for ground and Vcc. If there were 2 common rails on each side of the board it would be easier to deliver power and ground to any connection on a component or sub-board. As it is I end up with way too many wires trailing across the top and bottom of the board just for Vcc. So although the price and quality are good the layout could be so much better, hence only 3 stars.