Winkelwagentje

Winkelwagen is nog leeg.

Winkelwagen is nog leeg.
Op voorraad

Bluelover 3/4 inch irrigatie meststof injectoren apparaat filter kit venturibuis

6,99€ 15,69€
Gratis verzending bij bestellingen boven 25,99€

Productdetails

  • Inlaat/uitlaat schroefdraad: 3/4"
  • Materiaal: POM
  • Afmetingen: 139 x 72 x 33 mm
  • Lengte: ca. Buis. 2,26 m
  • Stroombereik: 0,65-2,42 m³/u


Productbeschrijving

Beschrijving:
3/4 inch irrigatie Venturi meststof injectoren apparaat
Toepassingen:
Meststof en chemische injectie door druppel- en irrigatiesystemen.
Functies:
Technische kunststof.
Uitstekende chemische bestendigheid tegen de meeste chemicaliën.
Zeer efficiënt en compact drukverschil injectie-apparaat
Economische en voordelige optie.
Verkrijgbaar in 3/4 inch BSP inlaat/uitlaat aansluiting
Bevat een injector met kunstmest, een waterslang, een flow-controller en een filter.
Specificaties:
Inlaat/uitlaatschroefdraad: 3/4 ''
Materiaal: POM
Afmetingen: 139 x 72 x 33 mm.
Lengte buis: ca. 2,26 m.
Pallet stromen: 0,65-2,42 m³/u.
Werkdruk: 0,7-9,5 bar.
Zelfaanzuigend vermogen: 9-92 l/u.
Inhoud van de levering:
1 x 3/4 inch irrigatie Venturi meststof injectoren.
1 x waterslang met schakelaar en filter

Veiligheidswaarschuwing

Let op: vermijd hoge waterdruk, installeer het uit de buurt van elektrische bronnen, gebruik bij de installatie beschermende handschoenen. Meststof niet inslikken en uit de buurt van kinderen en huisdieren houden. Vermijd direct zonlicht om de levensduur te verlengen.


JR
1 mei 2025
In contridiction to certain reviews here, the product actually does work. Problem in my opinion is there is no instructie or whatsoever shipped with the product so this leaves a lot to tinker with..I use the venturi to inject liquide fertiliser in my dripline irrigation system. My system pumps (measured) 1000liters of water per hour at plusminus 2,5 bar pressure, nothing unusual i think.What I found was;- the suction tube has to be as short as possible to maximise auction pressure by the venturi- to eliminate the risk of false-air suction its best to extra seal the suction tube connections withbty-wraps- the venturi for some reason works best when placed horizontally- suction flow increases when the suction fluid is placed above (higher than) the venturiLast but not least - very important - the suction has to be free of air before the fluid actually is moving. To get this, in my case a couple of sudden on-off valve change with the pump kept at normal speed did the tricky. Tube filled with fertiliser and after a few hours a couple liters of fertiliser where gone - and this being mixed in.Precise, no. Functioning, yes.Overall happy with the end result.
Simon Barton
8 april 2025
I Have just tried this, ordered a week ago inspired by a youtube vid. It works perfectly well for me. Turning the dial to just no 2, it syphoned up the liquid fertiliser immediately. I dont understand why it didnt work for other reviewees but can only think it was connected the wrong way round. I shall use it to fertilise my straw bales with leaky hose.
MaFi
23 februari 2025
Ich habe mir das Gerät gekauft um damit meinen Rasen mit Flussigdünger zu versorgen. In einen Eimer kommt der gewünschte Dünger und Wasser dazu. Dann alles angeschlossen und erstaunt wie gut das funktioniert. Durch den Regler kann man einstellen wie schnell der Dünger Eimer leer wird. Das System funktioniert sehr gut. Kann die negativen Bewertungen überhaupt nicht verstehen. Klare Kaufempfehlung....
Veronica v.
13 december 2024
Cumple con lo cometido
Mika M
6 december 2024
Fait bien le boulot prévu et intégrant le produit choisi dans une canalisation sous pression
IO proprio IO
4 december 2024
pacco arrivato tempestivamente. Qualità: nella norma immagino... in fondo, si tratta di un raccordo in plastica.... OKKIO AL MONTAGGIO!!! non te lo dice nessuno ma devi guardare sul raccordo ci sta stampigliata una freccia che indica il verso del flusso (inizialmente - per errore mio - avevo montato al contrario... ovviamente non funzionava nulla e stavo per restituire il tutto!).... altra cosetta... il rubinetto in dotazione non basta affatto! occorre creare un by-pass posizionando i rubinetti in modo appropriato (serviranno per regolare i flussi in modo da ottimizzare il tutto.... non serve altro... un minimo di applicazione e un filino di manualità.... anche nel caso di integrazione ad impianti temporizzati come il mio..... ho risolto il tutto in una mezzoretta attingendo a materiali di recupero.... SONO MOLTO SODDISFATTO DEL RISULTATO E DEL FUNZIONAMENTO COMPLESSIVO (si notino i rubinetti regolati semi aperti per massimizzare l'efficacia della aspirazione... poi, con il rubinettino sul tubo trasparente regolo la quantità di concimazione)