Winkelwagentje

Winkelwagen is nog leeg.

Winkelwagen is nog leeg.
Op voorraad

Bulina Dubbelzijdig plakband, 50 mm x 4,7 m, zwart, 1 rol 0,6 mm dik, 5925 schuimtape, zware belasting, extra sterk, voor autodecoratie, thuis, kantoor

11,99€ 27,81€
Gratis verzending bij bestellingen boven 25,99€

1.Maat:7 M


2.:Wit


Productdetails

  • HOGE KWALITEIT: 5925 plakband kan klinknagels, lasnaden en schroeven vervangen. De snelle en eenvoudig te gebruiken methode voor duurzame hechting biedt een hoge sterkte en langdurige duurzaamheid. Het bestaat uit een duurzame acryllijm met visco-elastische eigenschappen. Dit resulteert in een buitengewoon sterke dubbelzijdige schuimband en biedt met zijn visco-elasticiteit en het sterke vermogen om een groot aantal oppervlakken te verlijmen, vormflexibiliteit.
  • TOEPASSING: 5925 tape bestaat uit een duurzame acryllijm met visco-elastische eigenschappen. Dit resulteert in een buitengewoon sterke dubbelzijdige schuimtape die hecht op een breed scala aan substraten met hoge oppervlakte-energie (HSE), waaronder aluminium, roestvrij staal, composietmaterialen, acryl, polycarbonaat en gelakt of verzegeld hout en beton. Onze plakbanden bieden uitstekende schuifweerstand, oppervlaktehechting, duurzaamheid en temperatuurbestendigheid.
  • Functie: vrijwel onzichtbare bevestiging houdt oppervlakken glad. Kan mechanische bevestigingen (klinknagels, lasnaden, schroeven) of vloeibare lijm vervangen. Geen boren, slijpen, nabewerken, schroeven, lassen en daarmee verbonden reinigingswerkzaamheden meer nodig. Creëert een duurzame afdichting tegen water, vocht en meer. Drukgevoelige lijm hecht bij contact en zorgt voor onmiddellijke hanteerbestendigheid.
  • Plakband bevestigen: eerst de materialen uitlijnen en zorg ervoor dat alle oppervlakken schoon en droog zijn. Gebruik voor het aanbrengen van de tape een 50:50 mengsel van isopropylalcohol en water. Als de oppervlakken droog zijn, breng dan de tape op het oppervlak aan. Breng ten derde met een J-rol ten minste 100 kPa(15 psi) druk aan. Daardoor ontwikkelt u een zeer sterke hechting en binding. De bindingssterkte neemt toe na het aanbrengen.
  • INSTALLATIE: bij kamertemperatuur wordt na 20 minuten ongeveer 50% van de uiteindelijke sterkte bereikt, na 24 uur 90% en na 72 uur 100%. Opmerking: knip met een mes een hoek van de kleefzijde af om de folie gemakkelijker te verwijderen.


Productbeschrijving


3M dubbelzijdig plakband montagetape
3M dubbelzijdig plakband montagetape
3M dubbelzijdig plakband montagetape
3M dubbelzijdig plakband montagetape

Reiniging:

Reiniging:

Indien nodig een snelle voorreiniging van de moeilijkste plekken vochtige doek voor het verwijderen van verontreinigingen. Eindstap met een droge doek

Priming the Surface

TOEPASSING VAN DE PRIMER OP HET OPPERVLAK

Breng de primer aan op een wegwerpdoek, gevolgd door een droge doek. Spatelfles gevolgd door een droge handdoek. Schuimkwast, voor het lijmen laten drogen

Toepassingsgebied:

TOEPASSING VAN DE BAND:

Begin de band aan de rand van het oppervlak en verdeel deze met constante druk. Verwijder de beschermfolie om het andere substraat aan te brengen.

TOEPASSING FINAL PRESSURE

TOEPASSING VAN DE EINDDRUK

Dit wordt meestal bereikt door een druk van meer dan 15 psi op de tape uit te oefenen.

3M dubbelzijdig plakband montagetape

Livia G
14 juni 2025
I used this to stick double channel plastic track to the top and bottom of lightly varnished wood veneer shelves indoors.It’s very easy to use if you follow some basic rules:1. Remove grease and dirt from both surfaces before application and let it dry - I used isopropyl alcohol (available on Amazon)2. Do not pull the tape off the roll quickly - it will stretch if you do, then it will detach itself from the surface as it tries to shrink back to its original shape3. Use sharp scissors to cut and trim, not a blade - it welds itself to a Stanley knife blade as soon as you slide the blade across it4. Do not drop it on the floor - there are no side covers so you will find yourself picking off bits of fluff and grit for ages5. After applying to the first surface use fine point tweezers to peel off the red backing - use the same technique as for removing the backing from cardmaking foam pads.i.e. press down firmly with the flat edge of the tweezers onto the red tape, roughly 2mm from the end. This puts a dent in the tape and loosens up the very end of the red tape. Slide the tweezers under the red tape and peel. The dent does reshape itself after a couple of minutes6. Is it the correct product for your application ?I’ve read a few comments that say that this type of tape is rubbish because it was used to stick a hook to a painted wall. The hook fell off when a coat was hung on it. The tape stayed attached to the hook and it pulled off a large chunk of wall paint with it. This product is designed to bond to the surface it is applied to, not the substrates. Effectively they have used it to stick the back of the hook to a very thin layer of emulsion paint. It’s the weak bond between the paint and plaster that failed, not the tape.
Stefano Z.
3 juni 2025
Poco efficace. Non ha una buona tenuta.
Floratos Gerasimos
29 januari 2025
very difficult to unstick the protective material, strong enough for light things.
Dennis
1 december 2024
Wer 3M kauft der weiß was er kauft!Ich habe mir dieses Klebeband für einen Dosenhalter am Motorrad bestellt, dementsprechend muss es auch gut was aushalten (Geschwindigkeit & Vibratibonen). Ich habe die Klebeflächen erst mit Isopropanol gereinigt kurz gewartet und dann angeklebt. Wenn man nun wie in der Beschreibung wartet hält es Bombenfest. Ich habe mehrfach versucht den Halter wieder ab zu bekommen aber keine Chance. Top Kaufempfehlung !
JessGno
11 november 2024
Very strong the thickness was perfect for the item that I was using it adhere very good.