Winkelwagen is nog leeg.
Winkelwagen is nog leeg.Productbeschrijving
M24 x 1,0 rond snijijzer
Gemaakt van hoogwaardig gelegeerd gereedschapsstaal, volledig afgeschermd, geïntegreerde vormbewerkingstechnologie. Scherpe en harde schroefdraad; slijtvast. Conisch slotgat, sterke vergrendeling, grote capaciteit spaanverwijderingsgat, gladde spaanverwijdering.
Tips:
1ste Zorg ervoor dat je beschermende maatregelen neemt, je moet een veiligheidsbril en beschermende handschoenen dragen.
2de Controleer voor het aantikken of de diameter van het snijijzer geschikt is. Zorg ervoor dat je de juiste snijolie voor het complexe schroefdraadproces selecteert en na gebruik roestwerende olie voor onderhoud aanbrengt.
3de Het moet elke 1/4 ~ 1/2 cirkel worden omgedraaid om de spaanontlading uit het spangat te vergemakkelijken.
Adam and Laura
10 april 2025
If a die cuts too deep, the contact hold area is reduced and you either strip the threads or have a sloppy fit. This die left a little wiggle room but not too much and I torqued the parts down really tight without stripping.I was skeptical thinking this M24 2 pitch die would break and more so with the cheap handle I bought off amazon so I ordered 2... being fairly inexpensive.The die holder screws weren't in perfect alignment and I think that's on the die holder handle so I had to be extra careful.I'm not sure if there was a start side so I guessed.It would not start cutting at all until I flapsanded a slight bevel. Then it took alot of pressure and care to get it to align and get a proper bite.It did the job and I suspect a high end die would have had the same difficulties.Size matters. 24 mm is close too an inch so that's a big rod to thread. Took me about 1/2 hour total for a 1 inch long threaded surface.Lots of pressure and lots of backing out and restarting. I also used compressed air to clear the chips so it would bind less.I'm confused in that there are claims that the round ones cut new threads but the octagonal are strictly for cleaning up old threads. I sure don't see how that is but this round die cut fresh M24 2 pitch threads
bobos
13 januari 2025
conforme a la désignation mais le diamètre de la cage du porte filière n'est pas précisée ?
Customer
15 december 2024
Making threads
R. Braun
19 november 2024
Die is 55mm OD. It did cut a very nice clean thread. I ran it under power in my lathe using a large adjustable wrench with a dowel pin in the groove to hold the die. I only had to extend an existing thread 8mm longer than it was. It worked well.
mike sorge
17 oktober 2024
Fit fine, cut nice threads, and performed great. Excellent value for the money.
Aanbevolen producten
Misschien vind je dit ook leuk