CatEye CA5445340 Gopro Lichtbeugel Adapter, Zwart

having options for lights, camera with winter night riding action is noice. I run Cateye lights front and rear so this provides an option to use the GoPro mount on the K-Edge for the front light. I had already paid up for a K-Edge extended bracket to enable mounting of both my Garmin Edge 1030 and GoPro camera. Then I discovered Cat-Eye makes this mount to adapt to the GoPro bracket "fingers".My only issue is the fit is very tight. Fit for the headlight into the Cateye bracket is very tight. It does lock in so rather tight than loose. Also, I had some difficulty getting the Cateye plastic bracket to enter and line up between the K-Edge aluminum GoPro fingers. I anticipate this will loosen over time because the aluminum fingers already shaved against the Cateye plastic. But, hey, once mounted it enables use of the K-Edge to run the headlamp at night when I typically don't operate the GoPro camera.

Sehr gute Zusatzhalterung (z.B. Licht oder Kamera) für den Garmin Mount!

レックマウントGoPro用バーマウントType7と併用。板ヤスリで加工必要ですが削り過ぎ注意。中央部分に板ヤスリ挿し込んで数往復でOKです。加工というより誤差を修正するイメージ。安くて頑丈でオススメ。

Artigo vendido e expedido por Amazon. Comprado em conjunto com outros mas a entrega foi excessivamente demorada - 8 dias. Restantes items das 2 encomendas que fiz foram entregues muito mais rápido, mesmo não sendo produtos vendidos pela Amazon. O produto em si funciona mas as dimensões não são as mais exactas e o encaixe num suporte GoPro é muito difícil.

Review of Cateye GP Bracket for GoPro mount 5445340.Bracket arrived promptly in sealed Cateye packaging and seems genuine. Packaging says Cateye Volt lamp models 300, 400, 700 and 800 fit the mount, but no mention of AMPP lights. However, my AMPP 400 clipped into it just fine and I understand that the same attachment is used throughout the AMPP range, so be reassured.I am using a Barfly out-front Garmin mount with a GoPro mounting below, this plenty of room for my lamp. The Cateye GP Bracket was a VERY tight fit and I could not get it into the GoPro mounting. I rounded the edges of the bracket a little with carborundum paper then managed to get it in and the bolt holes aligned.The Cateye GP Bracket comes with a bolt and washer, but bizarrely no nut. Fortunately, I already had a nut and bolt set that fitted so used that. The Cateye GP Bracket locked solidly in place with minimal torque applied to the nut and BOLT.My AMPP lamp attached easily and securely by sliding in from the front to lock position and released equally easily (but it was upside down).A brake cable ended up resting on the front right of my lamp, but I tested safety by steering full left and right a few times and cable did not catch around the lamp (check similarly unless you have a death wish!).There was no MOVEMENT of the Cateye GP Bracket whatsoever after a long, bumpy ride with AMPP attached.Cateye GP Bracket looks well made, very sturdy and definitely worth the £6.99 I paid [sob!].Please like this review if you do!