Cloudray Hoogspanningskabel Adapter Connector B voor D5.2-5.5mm Aansluiten CO2-Voeding en CO2-Laserbuis

Gute Verarbeitung und leicht zu verbauen

Mi è piaciuto tutto, comforme alla descrizione del prodotto

I had to change my laser tube and needed something to protect the join on the high voltage cable. The tube came with wires already attached so I needed to join onto them. So, you have to solder then add silicon adhesive and cover with high voltage insulation not just electrical tape. It’s not hard but still takes time. This on the other hand is so simple. There isn’t any instructions but basically, slide the the soft black rubber over your wire, then the main housing, insert the cable into the little connector and tighten a screw. Pull it all together and then do the same the other side. Drop in the little rubber ring and screw the two pieces together which connects the male and female. Remember the female side is connected to power side and male comes from ground. You can get them cheaper but there is a much longer wait for delivery.

It worked well, easy assembly, however i was unable to tighten it fully to the bottom(possibly a gap of 1-2 mm) it works fine, and no issues though, so i guess it's as it is supposed to be.

1a ….danke