DAYUAN Innerlijke Lager Trekker Set Remover Slide Hammer Interne Kit 8-32mm 9st Blind Gat

The collet that the manufacturer says is for 15-17 mm starts out at 16.0mm, so you have to compress it with two pliers (which is extremely unergonomic) to get out a 15 mm bearing.The collet one size smaller only goes to 14.6mm when you screw in the pin fully.Didn't try any other collars. Build quality is decent.

Acheté pour extraire 2 roulements de 22mm bien rouillés. Ils sont sortis en 3 ou 4 coups de marteau coulissant. L'outil n'a pas été abîmé. Toutefois, ça reste du chinois pour usage occasionnel

Spitze

De media kon niet worden geladen.

I needed to pull a tapered pin with an internal thread from a machine and had to make up a piece of mild steel with a threaded end, so I could connect to the slide hammer, the other end of which I adapted to the thread of the pin. Notably, and I had to wait until the hammer arrived as I couldn't see it written anywhere, the main male thread on the end of slide is M12 x 1.75 (normal M12 course thread), which may help others in similar position. (I bought a female to female M12 adapter, and made a rod with a male thread which is easier.) The whole thing is nicely finished and much better than I had expected. Useful tool.

It’s great for small engines like dirt bikes and quads. yes sometimes it slips out of the inner bearing, by I remove it so only the outer remains wich makes it far easier.I was skeptical of the reviews at fist but it’s a quality slide and fittings. Great buy for $50 that I should’ve bought months ago for my other engines.