DeWalt DT7604-XJ boor en verzinkboor met 4 snijden, 3 mm, Flip & Drive-systeem nr. 6

After using it for a few days, it just broke.

Avoir le porte embout adapté est mieux mais pas obligatoire

Ich habe einige hundert Löcher in Fichte gebohrt und gesenkt. Keine Risse beim Eindrehen der Denkkopfschrauben! Klasse! Man braucht nicht noch nen dritten Schrauber zum Senken bzw. muss nicht umspannen. Das Teil hat mir die Arbeit merklich erleichtert und die Standzeit ist bisher auch super!

Comoda e buca pure la consiglio 🤝

There are some countersinks a lot cheaper.....but this one is of a high quality. Now i will back this up with the fact that so far apart from breaking the pilot bit during drilling (not the fault of the bit, but by the fact i hit a hidden nail in the timber) it cut nicely and fast, the countersink has (as yet) not done the annoying habit of some of coming lose on the shaft of the drill bit and start not to cut just sit there and you have to keep tightening up the grub screw to make it work.Tip... when you put a new drill bit in the countersink...take the new drill bit and if you have the tools and can file a small flat on the new bit along the shaft (on one side and of coarse not on the twist) were the grub screw will be when tightened...this helps stop the drill turning inside the countersink.

Funciona perfectamente, buen producto, las cuchilla corta con facilidad, en melamina y estratificado. De momento se mantiene perfectamente afilado. El precio esta muy bien, y es de agradecer que se puede utilizar en el porta puntas exagonal sin ser necesario aflojar el mandril del taladro. Es el segundo que compro