DIYmalls 868 MHz ESP32 OLED LoRa V3 Board SX1262 + Beschermende LoRa Case Cover + 868 LoRa antenne voor Arduino Meshtastic LoraWan IOT (Pack van 2)

Easy to setup

Ottimo prodotto consegna puntuale

product exactly as described. if you are looking to get started with Lora and/or meshtastic, this is a great first purchase. you get 2 dev boards so you can use them to see/ talk to each other to make sure they are working and to experiment with them. easy assemblage and setup, no tools required other than a desktop or a laptop and a usb cable to connect it to your computer to flash/ install the firmware. there are plenty of great videos to walk you through it step-by-step. one tip: if your computer is not detecting the dev board during the flashing process, you may need to download annd install the serial drivers ( CP210X USB to UART bridge) .i went into this with zero experience with hobby radio or hobby electronics and am very happy with the results. if I can do it, you can do it, too!

Got it all put together -- watched some YouTube videos but still had issues programming the board -- might be something I am not doing right also -- keep trying to program it

No problems using this for Meshtastic. Antenna works and fit in the case. Some assembly was required but no soldering. It's not shown in the photos, but the product comes with header pins to be soldered onto the Heltec board if you wish, as well as a battery connector cable.