Dolphin Nautilus CC Plus automatische stofzuigerrobot voor zwembaden: reinigt de wanden van ondergrondse zwembaden tot 12 m

It does what it supposed to.Easy cleaning

De media kon niet worden geladen.

Er ist sehr bedienungsfreundlich zu handhaben. Er reinigt den Boden , fährt die Wände hoch, allerdings hat er ein bis zwei Ecken in Pool die er nicht so mag und die werden auch leider nicht sauber.Bis auf das finde ich ihn gut

Bellissimo, costa 1 botto ma vale i soldi che chiedono il cavo non si attorciglia mai, non fa rumore per niente è molto potente si arrampica sul liner fino alla linea dell'acqua, ho una piscina 10x5 soddisfattissimo da ricomprare!

After reading quite a few negative reviews, I had few major concerns when I purchased this expensive item. People reported that eero extenders could be a problem, robot stuck in the middle of the cycle etc. However, in my case I had no problem connecting to an eero router even without turning off 5GHz (eero offers such an option via application) It quickly connected and started cleaning the pool. It got stuck at 23% the first time, but was able to complete the cycle the next time. To be honest, after opening the pool it's not in the best shape, so I did anticipate it will take multiple rounds to clean it up. I did anticipate that after the first pass it would be 80-90% clean, but in reality it's about 60%, so I assume it will take 3-4 rounds to clean it up completely. Still much better than doing it manually. The length of the cable is more than adequate. I was surprised to learn that the control block is not waterproof, but water-resistant, so it should not be exposed to water (i.e. rain will be a problem) Well, it's a minor issue to me. Also, wall climbing seems to be exaggerated. So far, I have not witnessed waterline scrubbing (still learning) It does climb the walls, but stops short below the surface without reaching the waterline. Maybe some other routine does that - still learning. I did not see the software issues one of the reviewers described (cut the schedule line), though the need for the cloud connection is concerning (cloud connection did not stop the robot from moving though) Lack of notification on the phone when the robot is stuck or cycle complete is also slightly annoying. Simple thing to do and would save a lot of hassle. Cleaning the filters is a super easy process. Bottom line - so far so good. I'll see how it works in a long run, but it's definitely a huge time and energy saver compared to the manual cleaning.Update 3 days later. The pool is not sparkly clean after 5th cycle (1 is thorough, others are regular as I do not see much difference to be honest) Those disconnects from "cloud" are getting annoying. Usually, the connection restores rather quickly, but I had once to disconnect power to restore the connection. It seems wifi functionality of Dolphin can be improved. Also, I cannot get the robot to get to the waterline. The video shows nice waterline scrubbing, but in my case it stops on the first angle between floor and vertical wall rather than climbing to the waterline. Furthermore, I am totally puzzled by the sentence in the manual that the handle must be adjusted diagonally. What does it mean? How? Instructions are not provided. The handle can be adjusted, no doubt, but what is the right position? And what's the difference does it make? I guess I'll have to experiment or call Dolphin to figure out.