Donwind 20 stks 220819 nozzles & 20 stks 220842 Elektroden Fit 65/85/105 plasma verbruiksartikelen snijden troch

These consumables will cause constant misfires, poor cut quality, and have a very short life. Electrodes were sometimes blown out after only 25 pierces on 1/4" mild steel and would rooster tail and cut with severe angularity. I switched over to OEM and the difference in quality is night and day. With OEM parts I'm able to get through multiple 4x8 sheets at 1/4" thickness. With these I was using at least 3 sets of consumables per sheet.

Worst consumable I have ever used. Less than two minutes of cut on a 45 amp and these are melted and exploded. Not only did our business wait months for this product to come from China; we wasted our money. Swapped for the more expensive Hypertherm consumable and the difference was night and day. Don't waste your money on these. Picture shown is less than two minutes of 45 amp on 11 ga mild steel.

I’ve already cut a whole 4x8 sheet of 14 gauge and so far I couldn’t be happier!