Everbuild 50 mm x 45 m aluminium plakband, EVB2ALUM50

Simplemente es genial, ancha, pega una barbaridad y muy resistente.

I bought this to put round the edge of my kitchen worktop cut-out where I'm going to install a new induction hob. The hob instructions say you need to do something to protect a standard wooden worktop, so I put on 3 coats of heat resistant paint and then this tape on top, so most heat should be reflected back and leave via the airflow channels, rather than be absorbed by the worktop.I've done the same 3 coats of heat resistant paint and a layer of this tape to a board that is designed to fit below the hob but above the cutlery drawer. Again the instruction book says you need to put some sort of separation in otherwise your cutlery/utensils will get very hot. I've seen various plates available to buy, but they seem to be ones that get fitted into a new kitchen cabinet, rather than something designed for retrofit.The tape itself is surprisingly strong for how thin it is, but is still easy cut with a regular pair of scissors or a stanley knife, so that you can mould it properly around corners, etc. It's very sticky, so line it up carefully before sticking down, though if I'd only put a couple of mm of a corner down, I was able to quickly lift it up if needed.It's a very large roll for what I needed, but an excellent price for the amount. I'd envisage having plenty left after this job for other random things, even if they just need "silver" tape for the colour rather than the heat reflecting properties, etc. Then again, my parents are thinking about getting a new induction hob too at some point, but they have a posh worktop so may or may not need the second half of this roll.

Je m'en suis servi pour isoler un peu un boitier plastique contenant de l'électronique et émettantdes ondes parasites...Cà a aidé sa

Mycket bra

Good stuff, exactly what I needed