FACOM E.506-200S hoekadapter 200 nm Zwart

Edit: Sent it back. Bloody thing became useless, two different error messages and constantly having to take the batteries out... Avoid.The device turns itself off after a few minutes of not using it, so naturally you are inclined to turn it back on and often do so while you're holding it since it's attached to your tool. If you do so, and you try to use the angular setting, you will see a flashing "oooo" for about 1 minute before seeing Err4 - this requires the battery to be pulled or the device to time out to turning itself off again to reset. The hard reset mentioned in the manual does not work.Other than that the device is good, but this problem makes it hard to work with. To avoid it, keep it on a flat surface when you turn it on and do not allow it to roll around. Ensure if you have a stored angular setting to switch to that at least once before moving the unit while powered on, or you'll just end up having to reset it as above.

Bon produit, prix élevé mais faut savoir ce qu on veux , j ai pu serrer ma culasse a l 'angle préconisé a savoir 2 passes a 90 °.Ça va me servir pour le serrage en NM aussi .

Tresbon outil

Vraiment excellent.Très bonne visibilité et les leds qui s'allument au fur et à mesure de la progression du couple facilitent le serrage.A recommander sans hésiter.

produit d'occasion déjà utilisé et rayéDe plus le certificat date de 2018 pour un produit acheté fin 2021