FansArriche Epoxy hars - 800ml/850g kristalheldere voor gieten en coating - Easy Mix 1:1 verhouding transparant 2 deel hars voor tafelbladen, tuimelaar, sieraden maken, ambachtelijke

Prima product voor mijn project.Uiterst tevreden.

Mix in 1:1 proportion and pour in mould -> can’t get easier than that! Complete set with gloves and even some glitters for fun. Hardens quickly without giving off a lot of heat. Very clear transparant end result.

Leuk pakket met veel spulletjes om mooie dingen te malen. Voor een betaalbare prijs.

Ik heb het gebruikt om een kunstwerk te maken waarbij ik de epoxy hars als vloeimiddel te gebruiken met goud pigment. Werkt gewelsig!

Doet wat het moet doen

Tot nu toe de beste epoxy.

After 26h my coasters werent cured yet, I'm afraid the reason might be expiered product since one bottle had an open lid, I have them stored for over a month and didn't check, which is my bad ofcourse..

I used the resin to reinforce a lid on my boat.I poured the resin in the back of the lid, let it dry, and now I have a lid that can resist some serious pressure.Also: there were clear instructions for a novice like myself.

Cristallisation des le mélange ! Pièce chauffée a 25 donc pas d humidité dans l air

Jeszcze nie używaliśmy, ale paczka dotarła szybko i wszystko jest dobrze. Dzięki

Premetto che non ho mai lavorato la resina, per cui il mio commento è da neofita. Non ho avuto alcun problema di bolle mescolando lentamente non si formano. É quasi completamente inodore, ho usato la polvere brillantinata, bello l'effetto. Non ho ancora utilizzato le colorazioni. Quindi molto soddisfatta

Ich muss ehrlich zugeben, das ich am Anfang sehr vorsichtig war, da ich das erste mal mit Epoxidharz arbeite. Es funktionierte tatsache einfacher als erwartet. Das mischen war einfach und das gießen ist perfekt. Die Bläschen gehen von selber raus und die Aushärtezeit ist abhänig von der Temperatur des Raumes. Desto wärmer, desto schneller wird es hart und man kann es aus der Form entnehmen. Das fertige Harz ist Kristallklar und hart wie Stein. Perfekt wie es sein soll. Preis Leistung ist unschlagbar! Kann ich nur weiter empfehlen und ich werde immer wieder diesen Artikel bestellen, darauf könnt ihr euch verlassen.

Ok so I used this product to repair a missing heal and toe pads on my Nordica skiboots. Not a typical application I assume.The product flows very well with ample working time. I had no issues with hardening and adherence to the substrate. Following the instructions is easy. Carefully mix the amounts and mix well for a long time. Bubles disappear on heir own. The product levels itself and finds a way to flow away. So be careful not to overfill and seal cracks etc for it not to flow out.Before the product was fully cured I was able to easily shape the cast with a palm sander. The product did not clog my sandpaper. The product cured fully and is very hard and solid after 48h. I let it cure in the heater room where it was warmer than normal living quarters would be.I am very pleased with the result and for less than the cost of a day rental repaired my rear entry skiboots. My expectations were low but this exceeded my wildest expectations.