Festool Sargento de rosca FSZ 120

Festool kwaliteit

Coppia di morsetti con tripla funzione: morsetto tradizionale, morsetto da binario guida per seghe ad affonfdamento e morsetto da tavolo mft.Fanno ciò che devono, senza sbavature.Cari, in questo caso ingiustificatamente, ma indispensabili per chi possieda un tavolo mft o un binario guida (il mio è Festool, ma pare che funzioni anche con altri).Consigliati.

Trying to save money I bought a number of different clone clamps before I bought these. All I can say is DON'T! Lol. The closest were the Makita except the Makita don't fit the Festool workbench. They can be forced through the holes but the fit is tight and they damage the bench on the way through, creating a small flat in the circular hole. I ended up wasting more money than I was going to save. Buy the festool clamps. They may be a little more expensive but its only a few quid and importantly they are just that bit thinner metal so they slide through the 20mm holes without even touching the sides. I have added a picture of the two side by side. They don't look much different but believe me that slight difference in width of the steel bar makes all the difference.As you would expect they do the job. They are surprisingly tough. They aren't single handed, because they need to grip just a little before the arm stays still instead of sliding when you tighten them up, so you need to hold the arm and tighten until it grips, but they are good in all other respects. Although lightweight they are as useful as my old, heavy g-clamps because the jaws are big. I have now replaced my old clamps and just use these all the time for general stuff as well as on the workbench. I just wish they made some bigger ones that were a sensible price.I ended up with ten clamps and intend getting more. You can never have enough clamps.

Drill some 20mm holes in your assembly table and enjoy how well these clamps hold your workpiece. There ain't much more to say about that. But there is the added benefit of how well they hold your Festool tracksaw rail too. Yup, pretty decent all around. I can even clamp them with one hand, so ha ha to those people who don't like these because they have to use two hands. Sorry the world is so rough on you! #firstworldproblems are the worst!Anyway, I have yet to find a need nor even a desire to get the other Festool clamps. You know, the newer ones that are for one-handed use. I can twist there just fine. Saved a few coins and got some killer clamps!

Cumplen perfectamente su función, imprescindibles si utilizas guia festool, muy buena calidad, solo un pero y es el precio, 50 euros creo que es caro. Teniendo en cuenta que las mismas de Makita salen por 25 euros la pareja y se pueden utilizar en las guías festool también.

Utile avec circulaire plongeante et rail de guidage,compatible avec rail makita et certainement d'autre marques.À première vue de bonne qualité,on verra avec le temps.Prix plus cher que d'autre marques mais c'est du festool.