FoxAlien Stofschoen met een diameter van 69 mm voor CNC-router, compatibel met 52 mm spindelmotor en 65 mm router, slangdiameter 38 mm

This dust collector is simply awesome. I know that word gets used way too much, but the mess that this thing gets rid of is something to behold. If there were 10 stars it would get all of them.

Produit très qualitatif.bon produit belle finition

Fremdgenutzt mit einem (natürlich selbst gefrästen) Ring als Spacer. Funktioniert perfekt!

The perfect solution for my CNC machine. Excellent quality, strong bristles that aren't too long and risk getting caught on the bit. Recommended.

This works great on my FoxAlien WM3020 CNC. I have it connected to the FoxAlien HSF-800 vacuum cleaner and have the Genmitsu 710W spindle. Although the shoe is some what larger than the Genmitsu one for my 300W spindle it definitley does a better job at removing the dust.Couple of points to be aware of;1. Whilst the dust shoe is fully attached you can not see the cutting bit. This is not to much of a problem as the bottom half of the shoe that has the bristles on is connected be a couple of magnets and unclips quite easily giving full access to the spindle for changing bits.2. Make sure that there is a big enough gap between the bottom of your spindle outer case and opening of the dust shoe to make sure the debris can enter the shoe cavity. First time I used it I noticed that the suction was non existent then realised I had mounted the shoe to far up the spindle casing. Dropped it down slightly and it worked just great.