Winkelwagentje

Winkelwagen is nog leeg.

Winkelwagen is nog leeg.
Op voorraad

Fzone Aquarium ATO Auto Top Off Refilling System with Pump, Aquarium Water Refiller with Dual Optical Sensor, Upgraded QST Tech and Smart ETFT Algorithm for Both Reef and Plant Tank

36,99€ 79,00€
Gratis verzending bij bestellingen boven 25,99€

Productdetails

  • Compacte afmetingen: de gehele optische sensoreenheid heeft een diameter van SLECHTS 0,8 cm. Het apparaat werkt op omrande en randloze tanks en ook op cartertanks. De hele machine is ontworpen met een snelstekkermodule, die vrij is van installatie en supereenvoudig te installeren is. Het kleine formaat is niet alleen mooi, maar ook geschikt voor zoet- en zeewatergrastanks van verschillende afmetingen.
  • Nieuwe en verbeterde functies: verbeterde ETFT (Extended Time Filling Technology), AFT (Anti-fluctuation Technology) en QST 2.0 (Quick Security Technology). Met al deze nieuwe upgrades samen zijn onze ATO's veel beter en veiliger. ETFT herkent de grootte van uw tank nadat deze voor het eerst is geïnitialiseerd. In samenwerking met de ETFT kan de AFT beslissen hoe lang het duurt om uw tank bij te vullen zonder deze te veel te vullen wanneer het QST-alarm afgaat.
  • QST 2.0 realtime monitoring - Voorkomt overvulling en pompt de pomp droog. De controller geeft een visuele waarschuwing en stopt de pomp onmiddellijk wanneer hij een bijvultijd detecteert die meer dan 6 keer langer is dan de door ETFT berekende tijd. QST kan een storing in de sensor/controller of zelfs een leeg reservoir detecteren. In versie 2.0 hebben we de ETFT-functie en zijn we niet afhankelijk van de eerste vultijd vanaf versie 1. Overstromingen komen nauwelijks voor als je de instructies
  • Optische sonde met dubbele detectie: de optische sensoren met dubbele precisie bevinden zich op 0,1 cm afstand van elkaar, waardoor de niveaufluctuatie nauwkeurig kan worden gevolgd (minder dan 0,6 cm verschil). De sonde met dubbele detectie en uitstekende prestaties kan in een volledig donkere omgeving werken, u kunt hem met een gerust hart gebruiken!
  • Alles wat je nodig hebt is inbegrepen in het pakket - Krachtige magneet ondersteunt een glazen wand van 15 mm dik. Terugslagklep voorkomt dat er water uit de tank terugstroomt. Met de slanghouder kun je de slang eenvoudig bevestigen. De krachtige waterpomp van 70 gph kan water tot 2,5 m hoog optillen.


Productbeschrijving


1

Fzone ATO is a compact Auto Top Off system for all sizes of freshwater and marine aquariums. Combining the optical auto refilling sensor and an anti-overfilling sensor in one pack, along with integrated QST v2.0, ETFT, and AFT algorithm, the FZ-360P precisely keeps the water level in right position and provides real-time protection against any failure and abnormality. Using FZ- ATO to automatically replenish your water; maintaining a consistent salinity level better than manually and save you from this annoying chore.

1

SPECIFICATION

Power : AC 100-240V/50-60 Hz input, DC 12V/1A output.

Power cable length: 6ft(180 cm)

Sensor precision: 1mm

Pump head: 8.2 feet (250 cm)

Pump flowrate: 74 gph (280 lph) Max.

Mounting Thickness : 15mm

Length of Cable between Sensor and Controller: 6 feet (150 cm)

Tubing: 6feet(180cm), 7mm inner diameter.

1

Patented QST v2.0, EFTT, & AFT Technologies Ensure Constant Water Level

The Fzone ATO will start filling below the "LOW" position & fill slightly higher than the "LOW" position. The "HIGH" position will prevent overfilling. The newest Fzone ATO also has patented EFTT, AFT, & QTS technologies. These smart technologies allow the ATO device to work more safely compared to others on the market.

ETFT(Extra Time Filling Technology)

The Fzone aquarium ATO recognizes the aquariums size by timing how long it takes to fill the water from “LOW” to “HIGH” position & calculations a a extra filling time called ETFT(Extra Time Filling Technology). In normal working condition the device fills the water to the "LOW" position and will continue pumping for one extended filling time cycle until the water level reaches above “LOW” but never going above the “HIGH” position. The ETFT will precisely keep the water level between the "LOW" and the "HIGH" sensors. This unique feature allows extra time of rest between refills, therefore it increases the product’s life span.

AFT (Anti-Fluctuation Technology)

Most ATO’s in the market start and stop the water pump too quickly due to the water level fluctuation caused by many factors. The frequent starting & stopping will shorten the pump’s life span and efficiency. Our smart ATO uses AFT to identify and recognize any false water fluctuation; it only starts the pump when the level is below "LOW"

QST (Quick Security Technology) v2.0

The controller uses QST for real-time protection against overfilling and flooding. The controller will give a visual alert and stop the pump immediately when it senses a refilling time takes more than 6 times longer than the ETFT. QST can detect sensor malfunction or empty reservoir. In version 2.0 we incorporate ETFT feature and not relying on first filling time from version 1. Our ATO is far safer. Flooding barely happens when following the instructions carefully.

1

Built-in LED indicators to show working status!

Alternating red and blue: device is booting up/initializing.

Solid blue LED: Stand by.

Slow flashing blue LED: pump is refilling the water.

Fast flashing blue LED: Water lever reached HIGH sensor, anti-overfilling works. (After 10 seconds quick flash, the LED will become solid, no need to act)

RED LED flashing: QST 2.0 alarm. 6 times longer than ETFT (the time it takes to fill your tank, which is calculated during initialization, aka about 50% of the time it takes to fill from LOW sensor to HIGH sensor).

1

Q&A

When will the controller activate the pump to fill water?

When the water level is below the “Low” sensor, the controller will activate the pump to fill water. The controller slowly flashes a blue LED during the refilling

When will the controller stop the pump refilling water?

The controller stops the pump under 3 conditions:

1. Water level reaches the "LOW" position and continues until 1 ETF, the good working condition.

2. Water level reach up to HIGH sensor position, anti-over-fill mechanism stops the pump.

3. Water refilling time reaches up to 6x the extended filling time. Pump stops to avoid dry running, or over-filling.

Why in start-up mode does the water lever reach the "HIGH" sensor, and when normally refilling the water does it stop between the "LOW" and "HIGH"?

In start-up mode, the controller needs to fill the water to the "HIGH" position in order to recognize your aquariums size & calculate the EFT accurately.

In normal working condition the device fills the water to the "LOW" position and will continue pumping for one extended filling time cycle until the water level reaches above “LOW” but never going above the “HIGH” position. The EFTT will precisely keep the water level between the "LOW" and the "HIGH" sensors.

How does the device calculate the ETF?

The ETF is calculated in start-up mode.

When the water level is BELOW the “LOW” position, EFT is determined by ½ the time it takes to fill from “LOW” to “HIGH”

When the water level is BETWEEN the “LOW” and “HIGH” positions, EFT is determined by the time it takes to fill from “LOW” to “HIGH”


Frank Vugts
20 juli 2025
It operates until about just under a cm from the rim of the tank. This is great, even for nano tanks. The pump is amazing. It is tiny, just like the sensor, but manages to pump water all the way up to the tank without breaking a sweat. It has LEDs indicating the operation which can be seen in the tank. So, flawless low-profil system. The only downpart for me is the magnet. It will absolutely not drop the sensor, but the electrical wire can pull the sensor sideways or out of the tank. Something take care of. I would and will recommend the Fzone ATO to a friend.
J van der Weijden
9 juli 2025
De media kon niet worden geladen.
ヨウチャン
20 juni 2025
設置は簡単で、シンクの 壁を通して磁石がコントローラーを吸着します。ポンプは貯水器に入れられている。電源をつないでからでいい。・シンクの 壁 に 簡単 に 設置 して、 光学 センサーがシンクの面積を計算します。 製品は自動的に最初に水を加える時間を計算し、それによってそれ以降の水を加える時間を計算する。 水がこぼれたり、気が入ったりする点を恐れ ず、いつまでも手働で水を入れずにすみます。めちちゃ便利すべきだ。・ 温度管理が不要 。 緩やか に水量を増やし、 魚に優しい 。注意点 : 別の水槽に移動 したり、 水を加える場所を移動 したりすると、 光学センサは 水を加える時間を計算し直します。
Frizou
1 juni 2025
Content de mon achat, fonctionne très bien. Il faut juste nettoyer le capteur 1 fois par semaine.Installation facile.
Lucia
18 mei 2025
Il prodotto arriva correlato d’ istruzioni in Inglese, il montaggio è estremamente semplice, sul sito è presente anche un filmato illustrativo, in pratica non ci si può sbagliare.I cavi di alimentazione ed il tubo d’immissione dell’acqua risultano molto lunghi e quindi posizionabili dove si vuole.E’ presente anche un’utile valvola di sicurezza per il non ritorno dell’acqua, l’aggancio alla vasca del tubo d’immissione avviene tramite un supporto curvo a 2 viti in acrillico nel mio caso si è adattata perfettamente all’acquario con spessore di 6mm, penso che per come sia strutturata sia adattabile ad ogni spessore.La pompa è micronizzata ed è entrata perfettamente nel collo della tanica che normalmente uso per il rabbocco, pur essendo molto piccola non inficia sulla potenza, spinge forte ripristina il livello in pochi secondi.Il sensore è molto piccolo piu o meno come una moneta da un’euro l’ingombro in vasca è praticamente nullo, viene tenuto in posizione tramite una calamita che deve essere posizionata sulla parte opposta del vetro (vedi foto) , la calamita è molto forte ed il sensore non si sposta da dove è posizionato.Il led di stato si fa notare d’altronde è quello il suo scopo, penso che se dovesse dare fastidio si può pensare di attaccare lo strumento ad una presa temporizzata (impiega veramente poco a ristabilire il livello).Per quanto mi riguarda avendo una vasca aperta e visto l’innalzamento delle temperature non devo più preoccuparmi del rabbocco e posso lasciare l’acquario tranquillamente anche per giorni.Al momento non ho da segnalare difetti e sono soddisfatto dell’acquisto!
Tom1988
2 februari 2025
Reviewing this after about 6 months of use - This works perfectly, its easy to set up and hasnt failed yet. i fully trust this while im on holiday. It costs much less than my old ATO, even if it does fail i will buy again.
Pascal
24 januari 2025
Nachfüllanlage geht super hat nur ab und an einen kleinen aussetzer was aber nix macht