Winkelwagen is nog leeg.
Winkelwagen is nog leeg.Productbeschrijving
Specificaties:
Chipmodel: NE555
Ingangsspanning: 1.8V-12VDC
Het maximale uitgangsvermogen: 30 W
De maximale continue uitgangsstroom: 2A
Duty Cycle instelbaar: 0%-100%
Maat: ca. 32x32x14mm
Voorzorgsmaatregelen:
① Sluit deze DC-controller aan op de DC-voeding. Sluit nooit rechtstreeks aan op een huishoudelijke 220V AC-voeding, anders wordt deze beschadigd;
②Doe geen voeding groter dan 15V, anders wordt deze beschadigd;
③Dit is een 2A hoge stroomregelaar, die niet meer dan 0,5A continue stroom/de 775 motor/kinderautomotor kan aandrijven. Bevestig nogmaals voordat u koopt.
Inbegrepen pakket:
2 × PWM laagspannings DC-motorsnelheidsregelaar
2 × Snelheidsregelknop
LO
17 juli 2025
Keurige module, doet precies wat je verwacht. Voor wat het kost kun je het niet zelf maken.
Dionline
29 juni 2025
Very easely to install and they work perfect!!!
Arie lingen
17 mei 2025
Heb nog een endoscoop tegoed ps maand geleden ongeveer besteldIk wacht het wel af gr A.L
Kunde
8 maart 2025
Good quality!
Harrie v.
7 maart 2025
alles was zoals verwacht
A.F. Popescu
21 februari 2025
Stopped working after 1 day on a 1500W load!
Hans
20 februari 2025
doet wat hij moet doen
Richard
8 februari 2025
Na aankoop bleek dat niet elke ventilator gedimt kon worden met deze motor dimmers .
CoyoTe
26 januari 2025
Pour réguler la puissance d'un petit transformateur continu. Marche parfaitement. Je recommande.
paolo bertoncin
12 januari 2025
perfetto per regolare motori elettrici a 220V a spazzole
Pedro jose martinez escamez
29 december 2024
Ok
Andrea Cattolico
28 december 2024
I've always had the problem of typing at night when only a side lampshade is in the living room. A backlit keyboard was only part solution, as I couldn't find a decent one, so I went back to old-trusted Logitech and added a LED strip under the monitor.This had two problems: the light was on a wrong angle so not reaching the keyboard, and too bright so caused glare.Solved the former problem with a 3D printed housing for the LED strip, to keep it on a correct angle. While this little board solved the glare problem, a USB connector was soldered to it, the output to the LED strip, so I can adjust the illumination to the keyboard to any intensity.Problem neatly solved with very little money!
Kevork Normanian
22 oktober 2024
I only used one so far and is working as it should. No issues yet.
Aanbevolen producten
