GeeekPi Raspberry Pi 4 ventilatorkit, aluminium koellichaam met ventilator voor Raspberry Pi 4B & Raspberry Pi 3B + / 3B

I do not want to post a negative review without receiving some support first but I did not know how to contact support so here it goes:I received two thermal tapes for the raspberry pi 4. The Cpu tape is on good shape. The tape for memory and the controllers gave me a problem. The seal on the upside won't come off taking the glue layer and part of the strip with it. Is there anything I can do about that? Can I use one of the strips for the RPI3 as a replacement?

Ik gebruik deze heatsink + fan op een Pi 4B in de NESPi 4 Case.Het ding past goed en is redelijk stil.De temperatuur in de NESPi 4 Case is een stuk lager.De heatsink zit met plakkende thermische tape op de Pi vast.Door het verschil in hoogte van de onderdelen op de Pi 4B zit het alleen wel wat wiebelig.

De dingen die je moet plakken waren niet goed. De plaklaag kwam mee omhoog toen ik het papier eraf probeerde de trekken.Nu kan ik de koeler niet op de Pi 4 plakken. Kan helaas niet vast geschroefd worden.

get loss from the surface after 1 day athesive tape is in a very bad shape

My Rpi 4B would keep overheating without the fan, this thing does it’s job and does it wel, all heating issues have been resolved, and the thermal conductive pads provided for both Rpi3 and 4 were in good state and easy to install. If your Rpi is not laying on its back, I would recommend something, an adhesive or case to keep the heatsink down on the board

Fa quel che può. Raffredda. Buon prodotto.

Das GeeekPi Raspberry Pi 4 Lüfter Kit ist eine ausgezeichnete Ergänzung, um den Raspberry Pi kühl zu halten. Die Installation ist einfach und der Lüfter arbeitet leise, aber effektiv. Seit der Verwendung dieses Kits bleibt mein Raspberry Pi konstant kühl, selbst bei anspruchsvollen Aufgaben. Die Qualität des Lüfters ist hoch und er passt perfekt auf das Raspberry Pi Gehäuse. Ein unverzichtbares Zubehör für alle, die eine zuverlässige Kühlung für ihren Raspberry Pi 4 suchen.

hafif sessiz güzel iş görüyor

Used this on my Pi that I use as a PiHole - it's lived in a closed cupboard for years and was always idling around 56C and above - not terrible but not great - and crashed once or twice from overheating.Long story short, put this on the Pi with the high fan setting ( Noise level not too bad, but I wouldn't want it in an open space or desk ) and it's dropped to a consistent 34C, very nice.Installation is easy, slap the thermal pad on, squish the cooler over that, and follow the product page images for where to put the wires and you're golden.It fits on my Pi no problem, though it does sit at a bit of an angle due to inconsistent heights of components.