Needed thermal pads for solving VRM overheating issues on a MacBook Pro 16” 2019 (Intel) causing throttling of the CPU and GPU.Thermal pads were easy to cut to size and apply and the material is soft enough to compress where it’s needed, unlike some other brands I’ve tried in the past on other applications.

After searching the web/YouTube for the correct thickness of pads. Found the thickness I needed for both front and back of GPU. I have the latest version of Nvidia RTX 3080 Founders Edition. Which require different thickness than the original 3080 Fe. For the back, I used the 3.0mm thickness Gelid Extremes. For the front, I used 1.5mm thickness Gelid Ultimates. Under load, VRAM temp went from 96 degrees Celsius down to ~70 degrees Celsius. I redid thermal paste. However, I did recall what I had prior to modification. I used Noctua H2 thermal paste. Under load getting ~ 59 degrees Celsius for GPU temp. The temps are with 65% fan speed for GPU. When cutting pads for both front and back. Don’t be concerned with cutting pads to completely over cover the chips. Try to be as close as possible when cutting and covering the chips. Reason being is because you may risk thermal pad overlap sections of the PCB. That would prevent you from closing the GPU enclosure properly. Causing not a good contact with die and heatsink. Then you’d have to open the GPU again. And trim the pads. To get better and straight cuts of your pads. Get a clean sharp utility knife or surgical type of knife with a ruler. I bought a arts and crafts set that came with a couple of knives, cutting mat, and metal ruler. Helped lots in comparison to using scissors.

23 Mart'da sipariş ettim 30 Mart'da ulaştı. Ürün yurtdışında geldiği için makul bir süre olarak görüyorum.Öncelikle ürün orijinal, ben GPU üzerinde kullandım. Kullandığım kart modeli RTX 3080'de VRAM'ler yük altında 86 dereceden 75 dereceye kadar düştü.Ürün yurtdışı satıcı üzerinden geldiği için kargo ve gümrük masrafları biraz fazla oluyor. Amazon.com.tr ürünü satışa sunarsa daha güzel olur.

getting great gpu temps, vram under 80 at load on a 3080ti

These did the trick for my 3070 ti FE in 1.5mm thickness. The temperature ticker is closing out a MS flight sim session.

Perfect replacement for the garbage stock thermal pads on my old ZOTAC RTX 2080 that I restored from a scrap PC. The value is pretty good for two pads and the thickness was exactly what I needed. Much better temps now!