Winkelwagentje

Winkelwagen is nog leeg.

Winkelwagen is nog leeg.
Op voorraad

Geschikt voor Keihin FCR MX Carburateur rebuild kit 28 32 33 35 37 39 41

6,99€ 12,90€
Gratis verzending bij bestellingen boven 25,99€

Productdetails

  • Advantadge: Ons bedrijf is een produing fabriek
  • Wordt geleverd met 45 piloot en 88 hoofdjet, 65 starter jet
  • Past op 28 32 33 35 37 39 41 mm koolhydraten
  • Hoge kwaliteit aftermarket rebuild set ontworpen om OEM-specificaties te voldoen


Productbeschrijving

Past op 28 32 33 35 37 39 41 mm koolhydraten
OPMERKING: Dit is niet voor Suzuki DRZ400 modellen. Dit is voor de Keihin FCR-MX Carb. (Niet de reguliere FCR Slant carb) 4-takt racefiets modellen. Carb Carburateur Rebuild Kit zoals afgebeeld op foto 1. Dit is een foto van precies de items die u ontvangt.


Anthony
16 juni 2025
Everything fit. One of the gaskets was a little ragged looking but I used it anyway, so check them carefully. At least I got the mid body gaskets replaced at last. They really needed it. Accelerator pump orifice was plugged by the old deteriorated gasket.
James C
10 juni 2025
Pretty good kit , Has almost everything needed for a Suzuki DRZ 400 outfitted with a keihin FCR MX 39 rebuild and they fit mine just fine. The only parts it did not include are the air mixture needle o rings and the pump diaphragm, but they can be purchased separately. The rubber in the orings and seals seem pretty good. It did have some extra orings and one mid body seal that I did not need. If you are not sure what parts you need, I recommend taking your carb apart first and comparing this to what you have/need. I'm glad I did. Almost bought the wrong kit before taking mine apart. My bike runs like a champ now.
ぼなんざ
27 mei 2025
不足品があり、いちいち問い合わせなければならない。いまだに返事は無し。
Mark N.
14 december 2024
Pack contained 2x of wrong mid body gasket rather than 1x of each design as shown. Upper gasket to access slide was wrong size.. Other parts seemed fine.
Lennard Böhm
9 november 2024
Definately NOT fitting a FCR39MX!Some Parts fit, like top end and lower end sealing, but the rest is sadly not fitting. See attached photos.