GLOTRENDS PA09-X1 M.2 NVMe naar PCIe X1 Adapter voor 2230/2242/2260/2280 M.2 NVMe SSD, PCIe X1 Installatie

Works perfectly + Easy to install

Werkt perfect. SSD erin aansluiten en word zonder problemen gezien door Windows.

This just worked immediately and the transfer speeds are great too. Mine worked on PCI-E gen 4 speeds. The operating system is Ubuntu 24.04 and just worked. No special drivers or kernel rebuilds required.

Does not work tested on 2 pc's with win10 installed and multiple free lanes. The red light works but device is nowhere to be found.

ممتاز جدا وفر لي منفذ لكرت ال ssd m.2 ركز على نوع القطع لتتناسب مع المذربورد الخاص بك

I wasn't concerned that this is PCIE 3.0 x1 as the only available slot on the motherboard it was going into was PCIE 3.0 x1. Both the BIOS (UEFI) and the op sys (Windows 11) had no problem finding the SSD installed into this card. No drivers were required in my situation.

I give this 5 stars for doing what it is intended to do, which is to provide a way of connecting an M.2 NVME to a motherboard that has no dedicated NVME socket available. Installation is very easy and it can be fitted to low profile cases as well as standard size. The board has no additional circuitry other than an LED that illuminates to indicate access.However, it only has one PCIe channel so the data throughput is only marginally better than a good SATA SSD. If you are using this on an older motherboard that does not have an NVME slot/socket, then the BIOS will probably not allow it to be used as a boot drive or access it before you get into the operating system e.g. MS Windows. As such, it has limited use.Having discovered the above, I eventually decided to replace the motherboard, an old LGA1155, with a newer motherboard with NVME support built into the motherboard. The new motherboard and Gen4 NVME has made my aging Intel i7 2nd gen PC boot into Windows 10 in just a few seconds.If you want to use this adapter to just add some additional storage then it may be OK for you. If you want to use your NVME to operate as the Boot disk then this probably won't work and you will need to buy a SATA drive. Note that there are no SATA adaptors to convert M.2 NVME to SATA (at a sensible price), and SATA is slower than just one PCIe channel in any case. A native NVME socket will have 4 PCIe channels and will thus be a lot faster than SATA.

La tarjeta funciona muy bien, aumenta el rendimiento del equipo, sin embargo, si el equipo es muy pasado, no se reconocerá el disco M.2 como un disco de arranque.

This worked flawlessly. I plugged it in and it worked without any setup or driver installation (Windows 11). I'm getting 805 mb/s sequential read and 328mb/s sequential write from a 4TB drive. I'm sure I'd get more speed from a much more expensive card or just on an on-board or x16 interface, but that's plenty fast for my purposes. It's only an x4 pci-e slot, after all (the whole reason I got this one). It was definitely the right product for me, since I only had a single, x4 slot open on my motherboard.