Hiplok ANKR, Ancora di sicurezza, Unisex, ALL BLACK, 10 cm x 10 cm

Der Hiplok ANKR Sicherheitsanker ist die ideale Ergänzung zu meinem Kryptonite Kettenschloss. Ich nutze beides in der Garage, und der Anker bietet eine sichere und stabile Möglichkeit, mein Fahrrad zu befestigen. Mit 10 cm x 10 cm ist er kompakt, aber dennoch robust genug, um die nötige Sicherheit zu gewährleisten.Die Installation ist einfach, und der weiße Farbton passt gut zu meiner Garage. Der ANKR bietet mir zusätzliches Sicherheitsgefühl, da ich mein Fahrrad nun an einem fixen Punkt anschließen kann, der schwerer zu knacken ist als ein einfacher Fahrradständer.Wenn du auf der Suche nach einem zuverlässigen Sicherheitsanker für deine Garage bist, ist dieser definitiv eine empfohlene Wahl!

The bracket is bigger than expected but therefore easy to get the chain in. Really easy to fit, solid and well made. Took about 10 minutes to fit and solid on the wall. The inner bracket stops someone unbolting the fixings as this is impossible with the chain fitted. Very happy with the purchase

Solido, efficace e di design

Installed one of these in a brick wall. Marked out the holes with a sharpie and used a 6mm masonry bit (in fact I used two bits as the first one went blunt after the 2nd hole) . I suggest you mark the 90 mm point on the drill and then drill as far as you can using the drill fully back in the chuck and then extend the drill in the chuck as theres not much for the chuck to grip once its out far enough to drill 90mm. The screws provided take some effort to screw in, I used an impact gun and it struggled to wind the screws into the solid brick, so I used a 1/2 " drive t- bar to wind it in as far as I could and then a ratchet to tighten it fully. Its very solid and you can remove the screws to leave only 6mm holes in the wall. Perhaps it would be a better idea to use a sleeve anchor as this would be A LOT easier to install

If in the USA you may want to buy your own 1/4" (x 3" - 3.5") concrete screws and a 1/4" drill bit to install.I wish I had thought of that before I had drilled four 7/32" holes into the ground. I figured that was the closest to the 6mm bolts provided, but I struggled to screw them in to 7/32" holes. I ended up finding a 15/64" bit here on amazon that I could use to widen the holes slightly, after which I could get the bolts in.Otherwise I love this lock, it's small and sleek and secure. After searching for bike lock options for inside my home garage I settled on the ANKR and I'm very happy I did.One detail I couldn't find online ahead of purchase was the size of the opening, so here are some photos. It's about 1 3/4" high and slightly more than 2 3/4" wide.Also makes sure your bits are long enough. I initially bought a T30 driver bit that was too short - it needs to be able to reach down inside the casing. So to summarize:- A 6mm masonry drill bit able to drill at least 90 mm deep; or 15/64" bit able to drill 3.5" deep- A T30 driver bit at least 7.5cm or 3" long- A 10 mm or 3/8" hex Allen wrench