Hot-end Kit voor Anycbic Kobra 2, gemonteerde Hot-end Kit-Head Extruder Vervangingsset voor Kobra 2, Kobra 2 Neo, Kobra 2 Pro, Kobra 2 Plus, Kobra 2 Max High Speed 3D-printer

Le PTFE d'origine anycubic mesure 40mm pour une kobra 2 max. Celui vendu mesure 43mm il faut donc le couper. Les buses ont l'air de bonne qualité, les chaussettes de silicone aussi. A voir dans le temps.

Ottimo ricambio pari all originale con in più gli ugelli…consigliato per chi ha problemi con l estrusore

Compatible Anycubic Kobra 2 plus

Macht was es soll

This seems to be ok…I am using an anycubic Kobra 2 max. I had to shorten the blue tube by a few mm to get a good fit. Otherwise the head sits too low and smashed into bed when auto levelling. I shortened the tube with a pair of cutters and put the cut end into the head leaving the other end to accept the filament.Check carefully before you cut your tube, but this is the only way I could get it to work on my printer.