HUABAN 50PCS 2 Watts 2W 240K Ohm 1% Metaalfilmweerstand

I needed some 240KΩ 2W resistors for a project (specifically two of them in parallel to get a total of 120KΩ), ideally as close to that number as possible without spending a ton of money for extremely low tolerance. Because I knew these were a random brand, I decided to test the resistors using a 5.5 digit bench multimeter with a 4-wire measurement probe (range set to 2MΩ). I left the probe clipped on to each resistor for approximately 30 seconds and recorded the results. It appears that all of the resistors were I did expect some that were outside of the 1% range, but unfortunately ALL of the resistors I got were over 240KΩ; which means that there is no way to balance them out to get my desired 120KΩ. One star removed due to resistors being +0% to +1% (no minus tolerances) as well as nearly half of them being over 1% tolerance. (I think based on the batch of 50 that I got that it would be more accurate to describe these as 2% tolerance resistors.)