Hydraulische Topstang Cat. 2 +2 Haken 530-740 Slagvergrendelingsblok 2x Slangen

I have installed and used it.This thing is great. 10/10, highly recommend. Based on this experience I will purchase from this seller again. I wish they sold some other things that I’m looking for!Plus points:* Came with everything I needed: Hoses, copper crush washers, ISO (Pioneer) 1/2" poppet style male connectors to connect to the tractor, banjo fittings to connect to the cylinder, fittings have covers. Did not come with the pin, and this is to be expected.* Phenomenal shipping - I did not expect to have this till next week. Ordered on Wednesday, it arrived at my place in New England on Friday, much to my surprise.* Holes (on the lock block and the banjo fittings) had plugs to keep out debris.* Ball release works.Minus points:* It was spray-painted pretty roughly. The ball on the tractor end is stuck because of the paint (easily fixed with some loving gentle persuasion of the mallet type).* Surface finish under the paint looks rough at first glance - probably just the casting finish.* Seems like it might have been packed as soon as the paint was surface dry. The cardboard did adhere to the paint a bit. I'll have to scrape it off prior to re-painting.* Styrofoam blocks used in the packaging got damaged and a lot of small bits of styrofoam was flying around inside the box. As a result, little balls of styrofoam got crushed against the cylinder and looked like polka-dots in the paint. They did brush off. Maybe the seller can replace the styrofoam with something else (cardboard)?* Needed to tighten the pre-installed banjo bolts as they leaked after a couple uses.At this price point, assuming everything works, I have no complaints. I only gave four stars for now, will upgrade or downgrade depending on how well it works.

Der hydraulische Oberlenker ist ganz ok.Leider sind die Hydraulikschläuche für manche Anwendungen 10 cm zu kurz. Auch der Umbau der Schläuche ist durch die verwendeten Armsturen nicht ganz einfach.

kam mit Transport bzw. Lackierschäden an.nach einigen Tagen im gebrauch war der Oberlenker undicht, Dichtungen bei den Anschlüssen des Zylinder wurden durch die richten ersetzt (Original war der Durchmesser der Dichtscheibe zu klein - somit drückte sie sich am Gewinde hoch)Im großen und ganzem, mit kleinen Wehwehchen, verwendbar.Kunden Support war gut und bekam auch Ersatzteile für die Dichtungen.

This cylinder is heavy duty and works as should. It fits about an 1 1/2" longer than stated but I was able to make it work. Also, the paint job is bad to say the least and seems to have been boxed while still wet so that the box stuck to it. The paint had to be honed out of the pin holes so they would fit. A little more QC at the factory on minor issues would easily get it a 5 star rating

Schlecht