Winkelwagen is nog leeg.
Winkelwagen is nog leeg.Productbeschrijving
Deze 10 Stuk Aluminium Router Bushing Set zal het gebruik van uw router aanzienlijk uitbreiden.
Voor sjabloongestuurde bewerkingen zoals zwaluwstaart, trapleiding, scharnier butt routing, omni jig sjabloon, lock face routing en andere algemene sjabloon bewerkingen.
De set bevat:
1) Bus gids: 10 12 16 18 20 24 30 mm
2) 67.5mm O. D. Adapter
3) twee borgmoeren (28,8 mm)
4) Past op KATSU Plunge Base SP10174805
Lennart Jonsson
23 juni 2025
The guide bushing set seems fine (have not tried them yet, but...- Beware that you need the additional base for the Katsu router to use them.- The bolts on the base that is supposed to hold the guide bushings sticks out below the base, you need to replace those (should be included with the guide bushings IMO).
holden
6 juni 2025
They work alright first use and the bushing broke but I wasn’t impressed when I ordered it and the advert showed a plastic container and when it arrived in a cardboard box with foam insert
Terry
9 mei 2025
So I decided to go for the blue ones as cheaper than the brass and to be fair don't expect them to get over used as it's only for home use they look to be adionised ally in the photos but are in fact painted this seemed to cause some tightness fitting some of the bushes in the base plate so needed to get a sharp knife and scrape the paint off the base plate to enable them to fit properly but for the cost I can live with that for the home DIY fan I say more than adequate but to be honest if it was for trade use I think I'd look at getting something of a bit better quality after all you get what you pay for but overall I'm satisfied with the purchase
fedilux
12 april 2025
Ware soweit ok, musste leider die Lackschicht aus den Gewinden "entfernen" ansonsten ganz OKwèrde nächstes mal die teirere Messingvariante nehmenfd
giampietro
20 januari 2025
Anno diverse tolleranze non sono calibrate uguali non sono precise
Aanbevolen producten
