KitchenAid 4162101 Vervangende tandwielwormonderdelen door KitchenAid

I have an older (~1988) KitchenAid KSM-5 Proline bowl lift model, one of the last of the ones with the Hobart engineering (has the motor brush screws on the side of the mixer head).My unit began to whine and overheat, particularly when I used higher speeds, when mixing a large batch (~1,000g) of bread dough -- perhaps the toughest job one of these mixers is subject to in home use.My dilemma was to repair or replace. After a review of more recent models, I found that an equivalent replacement to my old workhorse, relatively bullet proof KSM-5 model was a KitchenAid KSM-7 Proline, which costs ~$600, but is not as readily repairable. (In the KSM-7, if the motor or drive train gives problems, the whole motor assembly must be replaced, unlike in my KSM-5, individual gears and components can be readily removed and replaced.)Since the one, which I had seemed to be overall of better build and service quality, and is much quieter in operation than KitchenAid 5 qt models commonly available in membership and big box stores, I decided that repair, if possible, was the best course.Though the motor and other features have changed a lot after Hobart sold the KitchenAid line in the early 1900s, this part fit mine perfectly and restored it to almost as good as new operation.Some disassembly and assembly is required to install. Clean out any and all old grease along with any worn bits of metal or plastic from the old gears. Thoroughly repack all the gears in the forward portion of the housing with a heavy grease such as "Food Grade Grease & Gasket by Ohoho - Compatible With Kitchen Stand Mixer," or "Impresa Products 4 Oz Food Grade Grease for Stand Mixer Universally Compatible."

NON È COME NELLA FOTO, L'INGRANAGGIO È NERO E NON AVORIO.X ESPERIENZA, QUELLO NERO DURA POCO

Genuine parts

القطعه مناسبة جدا وتم عمل الخلاط

perfect fit.