Winkelwagentje

Winkelwagen is nog leeg.

Winkelwagen is nog leeg.
Op voorraad

KS Tools 911.1275 5/16' Krachtbit, zaagsnede 14,0 mm

1,99€ 3,51€
Gratis verzending bij bestellingen boven 25,99€

Over dit item

  • Een passie voor gereedschappen van topkwaliteit: al meer dan 30 jaar lang zijn er voor ons geen grenzen.
  • Absolute topkwaliteit: meer dan 45.000 top-gereedschappen, waarbij alleen het beste goed genoeg is.
  • Innovatief in de productontwikkeling: onze uitvindingen hebben geschiedenis gemaakt en de markt veranderd.
  • Progressief wat betreft de prijsstelling: onze prijs-kwaliteitsverhouding is uniek.
  • Niemand is klantvriendelijker: dankzij onze service worden klanten fans.



Productbeschrijving fabrikant

Z

sleuf krachtbit

Fijnste chroom molybdeen stalen sleuf

Over ons:

Z

KS Tools Tools Machinen GmbH is een internationale leverancier van gereedschappen en werkplaatsuitrusting. Het in 1992 opgerichte bedrijf, gevestigd in het hessische heusenstam heeft momenteel meer dan 350 werknemers en negen vestigingen wereldwijd. KS Tools onderscheidt zich door een goede kwaliteit van de producten, een aantrekkelijke prestatieverhouding en goede flexibiliteit.


Manuel Silva
13 mei 2025
muito bom
Anders S
13 april 2025
They were up to the job. A bit coarse, they had to be a bit sharpened before they could slide into the slot. Because of the great torque it was a good thing with 8 mm attachment as I used an impact screwdriver with it.
Tom
9 april 2025
This bit is far to thick and will not fit any screws it’s useless, waste of money and they should have mentioned it and I wouldn’t have bought it
junger
28 januari 2025
Rapide et conforme
DM
13 december 2024
Usato in abbinamento ad un trapano avvitatore per sbloccare delle valvole di arresto con testa a taglio di un gruppo termostatico doccia.Se non fosse stato per questo inserto non avrei mai sbloccato le suddette valvole che invece ora sono tornate a svolgere la loro funzione perché ho avuto la possibilità di estrarle, ripulirle e ingrassarle.Sono stato costretto a limare la punta di questo inserto perché lo spessore che supera di poco 1,5mm non entrava nel solco della testa della valvola, ridotto allo spessore di circa 1,2mm e grazie alla potenza del trapano avvitatore ho svitato le valvole che avevo dato per impossibili da estrarre. Data la facilità con cui ho limato la punta dell'inserto, mi è sembrato che il metallo di cui è fatto sia un po' troppo dolce. In ogni caso, ottimo.