Winkelwagentje

Winkelwagen is nog leeg.

Winkelwagen is nog leeg.
Op voorraad

LP Latin Percussion Bongofell Aspire EZ Curve Velgen Maat 6 3/4' Macho - LPA663A

23,99€ 45,10€
Gratis verzending bij bestellingen boven 25,99€

Productdetails

  • LP Aspire skins in instapkwaliteit, dikte: ongeveer 1 mm
  • Bonthoogte (nieuwstaat): ca. 30 mm, materiaal: ongelooid buffelbont
  • Pasvorm velg: Alle Highline/Aspire EZ Curve bongo hoepels in de corresponderende maat, ook geschikt voor CP601 Combo bongo's
  • Let opGebruik, ondanks de kroondiameters van 7" en 8,5", alleen de originele Aspire skins. De buitendiameter van de Hand Picked en Matador versies is iets groter, waardoor de skin vastloopt in de EZ band. De originele Remo skins voor Aspire hebben een iets smallere aluminium hoepel. Daarom blijven de maatspecificaties 6 3/4" en 8".


Productbeschrijving

LP Latin Percussion Bongofell Aspire EZ Curve Velgen Maat 6 3/4" Macho - LPA663A


Yadivette
27 juli 2025
Good quality
Customer
29 juni 2025
LP Quality Head,Sounds and Feels Just as it looks! Superb. Top Service all Much Appreciated .Thank You.
Sherry
8 maart 2025
At first I was very skeptical about ordering a head replacement and to tell you the truth, I really didn't know how. But after many agonizing months of not playing my bongos, I decided to do it. I simply took off the old head and measured the top of the bongo where it had been fitting and used that measurement for the order. They fit perfectly. They are lasting very well, sound very good, and they look better than the original heads. I'm happy with this product and plan to order them again as a backup.
Carlos A. Arroyo
28 december 2024
VERY GOOD PRODUCT! I LIKE IT A LOT. GOOD QUALITY. GIVES VERY GOOD SOUND TO MY BONGOS. I HIGHLY RECOMMEND IT TO EVERYONE.
elgrivna
18 december 2024
I think these heads are fine, but they come with zero instructions on how to install. I wrecked the first one I purchased by mounting it dry, and trying to remove a ripple by tensioning. The new head tore along the rim line. I soaked the flat part of a second head in water for a half hour in water before mounting (to soften the rawhide), and that one worked perfectly. Check out youtube videos BEFORE trying to install natural skin heads!