LUTER 3D Printer Mondstuk MK8 Extruder Nozzle + Roestvrij Staal Naalden Reinigingsmondstuk Hoofd Printer Cleaner voor Makerbot Creality CR-10 (0,4 mm, 30)

Only used a couple since receiving them but I checked a bunch and they all look good.Has solid prints since using them.Come in a small case, these should last some time

These nozzles work on the CR10 V3. Using them increases the speed and strength of the prints. I am using .4mm layer height and 50% infill overlap into the walls. I was actually pleasantly surprised by the smoothness of the prints as I expected a much rougher look. I am suing the .8 mm nozzles on the CR10 V3 for faster and stronger prints. Pictured are supports to hold my printers up in the air and using 3.2 mm walls. The print takes about half as long, if not less, compared to the .4 mm. Both examples are using PETG. Zero stringing.These nozzles will not fit the Creality CR10 Pro V1 (and probably the V2).The quality of the nozzles is good. Make sure your slicer settings match the nozzle and preheat the hot end when making the changeover. I preheated to 250 degrees.

funktioniert

Links Orginal und rechts die Bestellte, ich finds super 👍, bestelle wieder.

Können bedenkenlos gekauft werden