MAKITA 423360-7 Goma antiastilla's van 3 m voor het dragen van de carril, voor cirkels en incisie

Works like a charm on a Makita guide rail. The rubber is firm and after more than 4 months the adhesion is still holding up well. Be sure to do the proper prep work before putting it on the rail though: remove old glue with acetone and remove any oil, grease and acetone with a bit of alcohol.

Good product is almost 1/3 cheaper the DeWalt version and fits perfectly

not as rigid as I would like. But does the job

è perfetto anche per binario di altre marche

I bought this for my Festool 1400/2 guide rail, I was initially skeptical about not choosing the genuine Festool version. However, at a third of the price, it was worth a try, and there’s enough to cover two 1400mm guide rails too.After removing the old splinter guard, I cleaned the rail with a Big Wipe, but the residue prevented proper adhesion. I then used rubbing alcohol on a microfiber cloth to remove the residue, and it then adhered perfectly.When trimming it down with the track saw, I noticed a difference from the Festool version. Instead of cutting off a strip, this one turned into crumbs which made a rite mess despite being attached to the extractor.First use was on 6mm MDF, it was easier to line up and delivered results that, in my opinion, were better than the genuine Festool version. It’s also noticeably sturdier.

Todo salio bien

Gör det den ska

passt perfekt auf die Makita-Schiene, klebt sehr gut.Natürlich muss vorher die Schiene komplett von Kleberesten gereinigt werden. Bei mir hats mit Kleberentferner und danach mit Verdünnung gut geklappt.