Messenslijphoekgeleider voor 1 x 30 bandschuurmachine (Combo Pack - 1 van elke hoekgeleider)

These "Knife Sharpening Angle Guide for 1 x 30 Belt Sander (Combo Pack - 1 of Each Angle Guide)" fit perfectly on my Harbor Freight Central Machinery cheapo belt grinder. If you're especially concerned about getting an exact degree angle, check it with some other equipment, e.g. angle gauge, protractor, like you would doing any other kind of precision work. For instance if you set one of the guides I got at 10 degrees indicator, it is actually more like 13.65 degrees. So if I needed a 10 degree angle, I'd have to lengthen the slot with a dremmel drill or something. The degree indicators are just stamped into the metal, and not intended to be super accurate. My only other comment would be that they come with some rough edges, that need to be ground smooth, that could scratch the side of your work as you press it against the guide. Buy hey, your standing in front of a grinder right? I couldn't make these for $30 bucks worth of time and they are easily cleaned up to fit my purpose.

As above

I like that I can adjust and set the angle. I don't like the fact that it doesn't secure to the sander and slips off while I am using it. It works best with wide blades, lawnmower, machetes, etc. Small blades, (pocket knives), are harder to hold on the angle guide.

recommend to anyone

I use this on a 1"-42" belt sander and the work perfectly on it even though it is marketed for the 1x30 . Great at helping maintain a consistent grind angle and get a razor sharp result on your sharpening projects.