Winkelwagentje

Winkelwagen is nog leeg.

Winkelwagen is nog leeg.
Op voorraad

Metalllenkgest?nge, RC Truck Upgrade-Teile Metallgest?nge f¨¹r RC-Liebhaber eingestellt

4,99€ 10,82€
Gratis verzending bij bestellingen boven 25,99€

Productdetails

  • Metal Material: metal material has high strength and it is to use for a long time.
  • Quality Design: Quality design in high efficiency, can reduce unnecessary energy loss.
  • Nice Replacement: High precision, matching models as replacement of original parts.
  • Easy to Install: Comes with a pack of screws, easy and convenient to install and remove.
  • Better Experience: Improve the performance of model car, provide a better experience for you.


Productbeschrijving

Features:
1. metal material has high strength and durability.
2. Reasonable design, reduce unnecessary energy loss.
3. High precision, matching models as replacement of original parts.
4. Improve the performance of model car and add more fun to your remote control.
5. It is easy and convenient to install and remove.
6. Fits for WLtoys 1/18 scale RC model cars.

Specification:
Condition: Brand New
Item Type: RC Accessory
Material: Metal
Color: As Pictures Shown
Size: Approx. 4 * 0.7 * 0.7cm/1.6 * 0.3 * 0.3in
Fitment: for WLtoys 1/18 Model Car

Package List:
6 * Steering Linkage Rods
1 * Wrench
14 * Screws


Ungerer
8 juli 2025
I used the turnbuckles in my 1/10 onroad car. Slightly hitting the curb and this happened. Quality not good
Sehr hochwertig
11 juni 2025
Top
Benjy
12 mei 2025
Just what I needed
Alessio
30 november 2024
I braccetti che dovrebbero avere una grande precisione, questi avevano tanto di quel gioco che appena li ho visti li ho riconsegnati... non consigliati
Phill
13 november 2024
I received this item all week n good, until I went to use it on the model I bought it for. I went to adjust it to size, 1 side went to within 2mm of the centre adjuster, the other side bound up 5mm away, which made it too long for purpose, as I needed to use it, I held the centre nut and turned the stiff side to see if it would get any closer. After 15mins of winding in and out gentle and lubricating it finally got within 2mm of the adjuster, which is just short enough for the specified purpose. I then put off curiosity checked all the others. Unfortunately they all had the same problem on the same side. I'm going to put these in file 13, and get some better ones, as a few of the ball ends felt notchy, and not smooth which will cause issues on my model and potentially damage other components, overall not happy. I feel they were very low quality and/or poorly manufactured.