Micro Swiss Direct Drive Extruder met Hotend voor Creality Ender 5

La impresora ha mejorado enormemente desde que lo instalé, cero problemas desde entonces y me permite jugar mucho mas con los parámetros de impresión sin el temor a “atascar” la boquilla.Como digo en el título, vale la pena la inversión.

C’est mon deuxième et je dirais simplement que l’usinage de ce produit est parfait. Un bonheur à installer pour un gain de qualité et de précision dans les impressions. J’attends la sortie de la V2 de cette extrudeur pour ender5 avec impatience !

Nice piece of kit. Easy install, just make sure it all lines up. Huge improvement in both print quality and the printer performance in general.The g code micro Swiss supply doesn’t work to set the esteps. But it is easy enough to adjust if using Klipper with a bit of math and a YouTube video to follow. I ran their Goode but didn’t note the previous esteps so I don’t know if it worked or not tbh. It under extruded 67mm when 100mm was requested so either way it was crap. 😆 easily sorted anyway.The only issue I’ve found is not an issue with the micro Swiss kit but that it out performs the stock cooling capabilities of my Ender 5 plus printer. Essentially my fans can’t keep up at high speed so are limiting the max I can run until I upgrade them too.Well worth getting… the Bowden style setup the Ender 5 plus comes with is just too long. This solves it.

Product was a simple install and it all works as intended.As another reviewer suggested, small filing is required on an ender 5 pro on the extruder stepper shaft to create a notch for the set screw.The whole modification took very little time, just make sure to properly calibrate the E-step afterwards for best performance

El paquete llegó en tiempo sellado y seguro, se instaló en una ender 5 plus, funciona perfectamente, llevo poco tiempo imprimiendo y ha sido fácil hacer los cambios e instalaciones.