Milescraft 1212 SignPRO Sign Making Kit voor Routers - 2,5 inch & 1,5 inch Horizontale letters (166 sjablonen), 1,5 inch & 2,5 inch. verticale nummers (80 sjablonen) - 3/8 '. router bit meegeleverd- complete kit

Wonderful! At first I didn’t like the setup. But after using on several projects. It works just fine! And for the money you get two size letters sets.

works very well ,I have made a number of signs now. the only drawback is you can only use wood the size of the template. I would be nice if they put an open end on one of the end clamps to shorten the the wood required to do a smaller sign and reduce wood waste.All in all a good product

Excelente herramienta muy contento 👌

The amount of parts in the box is a little intimidating but most of it is letters and number stencils which, to me, is a good thing.Assembly of the jig is pretty straight forward and the instructions are clear enough but I found it helpful to watch an instruction video. There are a few on Youtube, including Milescraft's own.In my rush to use the kit for a small project that I was just finishing I used it with a trim router. The trim router that I used didn't have a plunge base which meant that I did scuff the stencil with the spinning router bit as I brought the bit down through the stencil to the wood.This problem disappeared as soon as I attached a plunge base to the trim router. Using a plunge base means that the router guide bush is in place to protect the stencils and the router bit can pass/plunge through the router guide bush to the wood without damaging the stencils.After my third practise board/cut I was producing decent consistent lettering.The kit holds the stencils in a straight line for horizontal or vertical alignment.If you want to cut wording in a curve or arch you will have to improvise.I'm happy with the kit and if I lost it I would buy it again.I prefer using my cordless trimmer, no cable to get in the way and dust extraction makes it easier to monitor the cut.

Makes making signs so much easier and a joy.