MMOBIEL Glas Lens Back Camera Geschikt voor iPhone 11 zwart - incl. Pincet en Doekje

Parfait pour l'utilisation qu'il doit faire

Muy sencillo de instalar, y pega perfectamente. El cristal tiene un tono de color ligeramente distinto al original (es como más azulado y más transparente). Pero no afecta aparentemente en nada a la calidad de las fotos. Cambié solo uno de los dos cristales, y no hay diferencia entre una cámara y otra.Una muy buena opción, ya que Apple, en el iPhone 11, si se te rompe la lente de la cámara o la tapa trasera, no te los sustituye, te hace cambiar el móvil completo.

I will start by saying it did work. The kit was nice, although you will likely need extra tools do do the job - a fine sharp tool like a scalpel or exacto knife and perhaps needle nose pliers, some tape to pickup the small pieces of glass, perhaps a can of filtered compressed air to clean the area (carefully) and maybe something like a hair dryer with a concentration tool to warm the old glue to make it easier to remove. The big negative was the stickers for the replacement glass were separate from the glass itself, making fitting them a game of skill. Not helping the matter was the stickers being smaller than they should be, again making fitting far trickier than they should have been. Basically it was nothing like the photos where the sticker is wide and already affixed to the glass, complete with a handy tab to remove the backing paper. The glass circles were also I assume originally on small squares of paper to protect them - I say assume, as they were loose in the bag, with a couple of squares in the bag as well.I would note that because the stickers are smaller than they should be ie the width of the sticker is maybe half that of the original, it would not surprise me if in the future the glass simply falls out. Even if it doesn't, I am certain that the water resistance of the phone - which even with the best repair would likely be reduced - will not be as good as it could be.Other than that it was fine. The kit came with a microfiber cloth to clean the new glass before fitting - obviously would *not* use this on the lens itself. It also came with some tweezers, but frankly they were too big to use - much better off with needle nose tweezers and an exacto knife.Overall it did the job, so a solid pass, but let's call it a C+ ie OK but could do better in particular simply by having the stickers actually fixed to the replacement glass as shown in the pictures. A nice addition would be either a knife, although most people would likely have something suitable, or swapping the tweezers with needle nose versions. I think I might also get some of those lens protectors that go over the whole lens and surround - both to reduce the risk of the new glass falling out but also to provide a little more water resistance.

Mycket bra. Pincetten var i plast så inget att ha.

Semplice da montare sebbene difforme da quello rappresentato in foto. Nella foto appare una linguetta, evidentemente da sollevare che nel prodotto giunto manca. La superficie che copre la parte adesiva deve essere tolta con uno stuzzicadenti