Nieuwe Swivel 2 Manier Draaibank Frezen Verticale Dia voor MYFORD SUPER 7 ML7

Very poorly machined, I can't believe they can sell this. One of the tee slots is not machined straight. The slide gib screws are not machined straight. The fit of the slide on one side has over 11 thousand gap .The table has backlash. I will have to use loose fitting tee bolts because the base of the tee bolts will only catch one one side of the tee slots. Not a level machined surface on it. However, the table top is not too bad compared to the rest of the machined surfaces. In short, I would say crude castings and poor machining . I would never buy another product like this from India. This is a bluefox myford mill slide item .

Overall, the quality of this attachment is dreadful. Mine arrived in a damaged box that looked as if a mouse had chewed the corner away. Upon opening the package, I found the attachment encased in hardened grease which required a full strip and clean. Although the main pallet (that which has the t-slots milled into it) is accurate, the edges were sharper than many store-bought knives. The male portion of the sliding dovetail has been milled crooked with one side over 25 thou larger than the other. The location holes on the gib strip were filled with swarf. The black bracket that acts as retaining bearing for the leadscrew is not only completely inaccurate with the main hole far from centre, it also lacks any type of counter-bored bearing surface for the leadscrew on the underside. Thus, the action of the leadscrew can never be smooth. Along with these numerous flaws, the paint on my attachment also arrived with a significant gouge in the 90 degree bracket. Finally, despite being advertised as suitable for Myford series 7 lathes, the included t-nuts are oversized and will require grinding in order to fit the lathe. I am thoroughly disappointed and would not recommend this product to anyone.

What I liked? I like that I have at least something to start with...because the shiny handle on top of slide didn't survive the shipping. Will have to cut off the broken end from the feed screw and weld a new threaded end so I can install the handle again. There is joke packaging - 0.5 inch of styrofoam. Slide looks square enough, but you have to completely disassemble and wash clean it. The only reason I am not returning it, bks I am afraid that replacement will be even more damaged and I need to continue my project. I checked another feedback on seller from India who wraps slides super secure but it is long time to wait... So sad that nice items got damaged due cheap packaging.

This was better made than I expected it to be. The machining on mine was spot on, some of the casting was a little rough but I would recommend this to others.

This slide is so well made...exceeded all my expectations