PetSafe Staywell, 799-serie tunneluitbreiding, eenvoudig, nauwkeurig installeren, wit, 5,8 mm

Installed in an interior door, it looks very neat, you can cut it very nicely and click it together.

Hat perfekt gepasst

1. Measure the thickness of the door you wish to place the catflap into.2. Cut tunnel pieces along the grooves with kitchen scissors to the thickness of the door (Carefully).3. Assemble the tunnel frame (lining it up with the lugs on the tunnel and holes on frame) and attach it to the outer part of the catflap (you can use glue but it's not essential).4. Mark in pencil the outside shape of the tunnel frame on the outside of the door ( make sure that the outer frame is high enough to clear the frame on the door).5. Cut a hole in the door and slide tunnel into the hole. Mark holes for screws (on the outside of the door) and drill the hole marks.6. Place inner part of the catflap, (so slit for flap locking barrier is at the top) on the inner side of the door. Slide bolts into holes until they protrude through the outer catflap holes (depending on the thickness of door you may need to buy longer bolts) and place nuts onto bolts (nuts go on the outer frame between the raised lines).7. Do the nut and bolt finger tight and line up the inner frame so that it's lip sits within the tunnel sides then tighten screws and line nut up with the two raised lines either side of the nut on the outer frame ( this will stop nut turning when tightening screw).8. If necessary, cut the screw thread so the outer flap can close ( WARNING if you use a Dremel type cutting wheel the grinding will make the screw and nut hot enough to melt the plastic so do a little off of each screw at a time). 9. Stand back and admire your work ( push flap in and out to make sure of free movement) and you're done.

Facile a monter et extensible et recoupable

Es un alargador, para cuando el hueco que tienes en tu pared es mas ancho que el de la puerta

Ancora da installare