Picnic Tap 2.1 - klaar om geweldige glazen bier rechtstreeks uit een vat of growler te schenken zonder bierlijn en lekbak. Gemaakt in de VS. Ball Lock Low Profile (LOPRO).

Product very good. Slow poor of beer but no foam

I have 2 that have the low profile disconnect and 1 with the standard ball lock connector. I use all 3 in the club tent at brew fest. I am able to dispense the 3 oz samples without a glass full of foam. I cut one 'coil' off the flow reducer to increase the pour rate.The one thing I wish was possible is to by more of the spouts to replace ones that crack from set screws

I tried to use it immediately after getting delivered and all it did was make foam. I left it connected to cool down and after that, it pours perfectly. I was having trouble with my picnic tap before, didn't feel like figuring it out, buying longer and harder to clean tubing, etc. This thing is idiot-proof. Nothing to think about. Connect it, pour good beer.

***Note: I've since had a few of these and have had to knock off two stars. The replaceable twist tap either fails out of box or eventually goes bad and begins leaking. I've had to cut the black nut off and then install a traditional picnic tap on a short one inch hose cut using hose clamps. This item would have been more effective as an inline regulator rather than trying to incorporate a tap.***This is a fantastic breakthrough in picnic tap technology. Pours a decent head with no drips and no need to tilt 45 degrees. No more hoses tangling, no more hose cleaning, and no more fuss with math. The pour rate is a little slow but the core mechanism can be cut down to adjust that. This will now become a staple in my keg fridge.

I originally liked this item for my homebrew kegs, however, after a handful of uses it is a piece of junk. It’s a nice concept but it’s not reliable and not it doesn’t even connect to the keg pin lock. I do not recommend.